Sharp AL-2020 (serv.man5) User Manual / Operation Manual ▷ View online
7
2
Follow the installation procedure below to use the unit properly.
SETUP PROCEDURE
When using the unit for the first time, setup the unit following the procedure shown
below.
below.
* If you are only using the unit for copying, skip this step.
If the unit does not function properly during setup or use, or if a function
cannot be used, see "TROUBLESHOOTING THE UNIT" (p.62).
cannot be used, see "TROUBLESHOOTING THE UNIT" (p.62).
1 Open the package, and make sure that all the accessories are
supplied with the unit. (p.8)
2 Remove the protective materials. (p.9)
8 Now, you can copy (p.46), print (p.35) or scan (p.36) your
document.
3 Install the TD cartridge. (p.10)
4 Load the paper in the paper tray (p.15) or the multi-bypass
tray
. (p.17)
5 Plug the other end of the power cord into the nearest outlet. (p.12)
6 Install the software.* (p.19)
7 Connect the interface cable* (p.25) and turn on the unit. (p.12)
2
SETTING UP THE UNIT
8
CHECKING PACKED COMPONENTS AND
ACCESSORIES
ACCESSORIES
Open the carton and check if the following components and accessories are
included.
If anything is not included or is damaged, contact your authorised service
representative.
included.
If anything is not included or is damaged, contact your authorised service
representative.
PREPARING THE UNIT FOR INSTALLATION
1
Be sure to hold the handles on
both sides of the unit to unpack
the unit and carry it to the
installation location.
both sides of the unit to unpack
the unit and carry it to the
installation location.
Cautions leaflet
Software and
user documentation
CD-ROM
TD cartridge
Drum cartridge
(installed in unit)
9
2
2
Remove all pieces of tape shown in the illustration below. Then
open the document glass/SPF and remove protective materials.
After that, take out the bag containing the TD cartridge.
open the document glass/SPF and remove protective materials.
After that, take out the bag containing the TD cartridge.
3
Release the scan head locking switch.
The scan head locking switch is under the document glass.
If the switch is locked (
If the switch is locked (
)
, the unit will not operate. Unlock the switch (
)
as shown below.
To lock the scan head locking switch, hold up the catch in illustration
and
turn the center knob counter-clockwise 90 degrees until you hear a click.
AL-2040
AL-2020
Lock
Unlock
Grasp here and turn in
the direction of the arrow.
the direction of the arrow.
A
A
10
INSTALLING THE TD CARTRIDGE
1
Open the multi-bypass tray,
and then open the side
cover.
and then open the side
cover.
2
Push gently on both sides of the
front cover to open the cover.
front cover to open the cover.
3
Remove the TD cartridge from the bag. Remove the protective
paper. Hold the cartridge on both sides and shake it
horizontally four or five times. Hold the tab of the protective
cover and pull the tab to your side to remove the cover.
paper. Hold the cartridge on both sides and shake it
horizontally four or five times. Hold the tab of the protective
cover and pull the tab to your side to remove the cover.
4
Gently insert the TD cartridge
until it locks in place while
pushing the lock release button.
until it locks in place while
pushing the lock release button.
4 or 5 times
Lock release button
Click on the first or last page to see other AL-2020 (serv.man5) service manuals if exist.