Sharp LL-S242A (serv.man6) User Manual / Operation Manual ▷ View online
13
E
Connecting the Monitor to a Power Source
Caution
• Use only the AC adapter and power cord supplied with the monitor.
1. Connect the monitor to the power outlet using the supplied AC adapter and power cord.
AC adapter core
Core restrainer
Back of monitor
AC adapter
connection terminal
Power cord
(Supplied)
AC adapter (Supplied)
For power
outlet
2. Push the AC adapter core into the core restrainer.
14
E
Installation
You can install the touch display for each monitor in the
following positions.
Installation position
LL-S242A-W
LL-P202V
Standing
position
Rack stand
Yes
No
Variable stand
No
Yes
Pen writing position
No
Yes
Horizontal position
Yes
Yes
Installing on a stand
(Standing position)
(Standing position)
n
LL-P202V
Placement on the variable stand
Place the unit on the supplied variable stand.
Caution
• The variable stand is designed for placement of the unit in
the landscape orientation. It cannot be used for the portrait
orientation.
• When connecting the stand, spread a soft cloth on a stable
level surface such as a desk, and gently place the monitor
on it with the screen facing down.
• Applying excessive pressure to the LCD panel with your
hands may result in damage to the unit.
• Be careful not to get your fingers caught when adjusting the
angle. There is a risk of injury.
1. Place the variable stand on the rear of the monitor,
insert the fixing screws and tighten by hand to position
the stand.
2. Securely tighten the fixing screws using the supplied
hexagonal wrench.
3. Place the monitor in the standing position, and adjust
the angle of the stand.
Hold the top of the display with one hand so that it does not
fall over, hold the rear leg of the stand with your other hand,
and adjust the angle of the stand.
The legs can extend about 20 to 75 degrees in relation to
the flat surface.
20°
75°
15
E
n
LL-S242A-W
Placement on the rack stand
Place the unit on the supplied rack stand.
1. Attach the back of the stand to the front.
Position the front and back sides parallel with each other
and attach the hinge.
Back
Front
Front hinge part
Back
Support
Tape
Front
Back hinge part
2. Spread the base of the front and back sides.
3. Peel off the adhesive tape securing the support to the
back side.
Back
Support
Tape
4. Fold down the support, inserting the tabs into the
holes on the front side.
5. Position the stand.
6. Place the monitor in the stand.
Landscape orientation
Run the cables out between the legs of the back side.
Installation
16
E
Portrait orientation
Run the cables along the hollow on the front side and out
between the legs of the back side.
7. Secure the monitor to the stand using the two fixing
screws.
Landscape orientation
Fixing screws (supplied)
Portrait orientation
Fixing screws (supplied)
Disassembling the rack stand
Remove the monitor from the rack stand before disassembling
the stand.
Caution
• After removing the monitor from the rack stand, store the
screws safely so that they cannot become lost.
1. Remove the screws and remove the monitor.
Remove fixing screws
2. Disengage the tabs of the support on the front side,
and raise the support.
3. Fold the stand closed so that the sides are parallel and
separate the front and back sides.
Installation
Click on the first or last page to see other LL-S242A (serv.man6) service manuals if exist.