Panasonic AG-DVC30P / AG-DVC30E / AG-DVC32EN / AG-DVC33MC / AG-MYA30G Service Manual ▷ View online
DIS-1
1. Note when inserting Flexible Cable
The flexible cables, have two sets of contacts on each cable, see the figure below. When inserting these cables
into the connector, make sure that the cables are fully inserted, if not they may damage the connector.
2. Disassembly Flowchart
CONNECTOR
FLEXIBLE CABLE
(REAR SIDE)
(REAR SIDE)
TWO CONTACT
POINTS
POINTS
3. MIC Case Unit
11. LCD Unit
4. Side Case R Unit
5. POWER C.B.A.
6. TOP VF Unit
7. Front Case Unit
8. Lens Unit
9. Rear Case Unit & CAMERA C.B.A.
10. Cassette Cover Unit
12. EVF Unit
11. Mechanism Unit & VTR C.B.A.
DIS-2
3. Removal of MIC Case Unit
1. Unscrew the 6 screws (A) and remove the MIC Case Unit as shown in figure 3-1.
Figure 3-1
MIC CASE UNIT
SCREW (A)
SCREW (A)
Remove the Hood unit, before disassembly of unit.
DIS-3
4. Removal of Side Case R Unit
1. Remove the MIC Case Unit.
2. Unscrew the 10 screws (A) as shown in figure 4-1.
3. Disconnect the connector P6403 on R SIDE C.B.A. and remove the Side Case R Unit as shown in figure 4-1.
Figure 4-1
SCREW (A)
SCREW (A)
SCREW (A)
SCREW (A)
SCREW (A)
P6403
SIDE CASE R UNIT
DIS-4
5. Removal of POWER C.B.A.
1. Remove the MIC Case Unit.
2. Remove the Side case R Unit.
3. Disconnect a connector P1001 on POWER C.B.A. as shown in figure 5-1.
4. Unscrew the 2 screws (A) and remove the POWER C.B.A.. Be careful because the CAMERA C.B.A.(bottom
side of POWER C.B.A.) and the connector in the POWER C.B.A are combining the one connector.
(Note in installation)
1. In case new POWER C.B.A. is installed, put the Cooling Sheet in following position as shown in figure 5-1.
Figure 5-1
SCREW (A)
POWER C.B.A.
P1001
There is a direct connector in
the backward.
COOLING SHEET
(Two sheet)
(Two sheet)
COOLING SHEET
SCREW (A)
Click on the first or last page to see other AG-DVC30P / AG-DVC30E / AG-DVC32EN / AG-DVC33MC / AG-MYA30G service manuals if exist.