PT-RQ13K — Panasonic Projector Service Manual (repair manual). Page 4

View Panasonic PT-RQ13K Service Manual online

4
PREFACE
< RQ13K >
 
r
Do not install the projector at an altitude of 4 200 m (13 780') or higher above sea level.
 
r
Do not use the projector in a location that the ambient temperature exceeds 45 °C 
(113 °F).
Using the projector in a location that the altitude is too high or the ambient temperature is too high may reduce the 
life of the components or result in malfunctions.
The upper limit of the operating environment temperature differs depending on the altitude or the [OPERATING 
MODE] setting in the [PROJECTOR SETUP] menu → [OPERATION SETTING]   
 
Altitude above sea level
Setting for [OPERATING MODE]
[NORMAL], [USER1], [USER2], [USER3]
[ECO], [LONG LIFE1], [LONG LIFE2], 
[LONG LIFE3]
Altitude of 0 m (0') or higher 
to lower than 1 400 m 
(4 593')
0 °C (32 °F) to 45 °C (113 °F)
0 °C (32 °F) to 40 °C (104 °F)
Altitude of 1 400 m (4 593') 
or higher to lower than 
2 700 m (8 858')
0 °C (32 °F) to 40 °C (104 °F)
Altitude of 2 700 m (8 858') 
or higher to lower than 
4 200 m (13 780')
The projector cannot be used.
When the Smoke Cut Filter is used, the operating environment temperature should be between 0 °C (32 °F) and 
35 °C (95 °F) regardless of the [OPERATING MODE] setting. It cannot be used at an altitude of 1 400 m (4 593') 
or higher above sea level.
 
r
Projection in all 360° direction is possible.
360°
360°
360°
360° vertically
360° horizontally
360° tilted
(combination of vertical and horizontal)
 
r
Cautions when setting up the projector
 
f
purposes may damage the projector.
 
f
The adjustable feet can be removed if not needed in the installation. However, do not use the screw holes 
holes of the adjustable feet. Failure to do so may cause damage to the projector.
 
r
The projector may not work properly due to strong radio wave from the broadcast 
station or the radio.
If there is any facility or equipment which outputs strong radio waves near the installation location, install the 
, wrap the LAN cable connected to the 
<DIGITAL LINK/LAN> terminal using a piece of metal foil or a metal pipe which is grounded at both ends.
 
r
Focus adjustment
The high clarity projection lens is thermally affected by the light from the light source, making the focus unstable in 
the period just after switching on the power. It is recommended that images be projected continuously for at least 
30 minutes before the focus is adjusted.
Page of 127
Display

Click on the first or last page to see other PT-RQ13K service manuals if exist.