Panasonic UB-T780 Service Manual ▷ View online
41
UB-T780
6.4.2.4.
Pen Tray Covers
Before performing the following steps, remove the lower front cover (refer to the section 6.1 “LED Board and Control Board”) and
side cover R (refer to the section 6.4.2.1 “Side Cover L, Upper Front Cover and Side Cover R”).
side cover R (refer to the section 6.4.2.1 “Side Cover L, Upper Front Cover and Side Cover R”).
1. Remove the 2 wing bolts to release the eilte Panaboard from the stand (Figure-A).
2. Remove the 6 screws (H).
3. Remove the pen tray cover front with a pen tray.
4. Remove the 3 screws (I) and pen tray cover back.
2. Remove the 6 screws (H).
3. Remove the pen tray cover front with a pen tray.
4. Remove the 3 screws (I) and pen tray cover back.
42
UB-T780
5. Open the pen tray as shown in the Figure-1, and move the pen tray in the direction of the arrow (2) . (Figure-2)
6. Remove the 3 screws (J), then separate the pen tray outer from the pen tray inner. (Figure-3)
6. Remove the 3 screws (J), then separate the pen tray outer from the pen tray inner. (Figure-3)
43
UB-T780
6.4.2.5.
AC Inlet
Before performing the following steps, remove the lower front cover (refer to the section 6.1 “LED Board and Control Board”) and
side cover L (refer to the section 6.4.2.1 “Side Cover L, Upper Front Cover and Side Cover R”).
side cover L (refer to the section 6.4.2.1 “Side Cover L, Upper Front Cover and Side Cover R”).
1. Remove the screw (A) and ground harness.
2. Disconnect the inlet harness.
3. Remove the 2 screws (B), ground harness and AC switch unit.
2. Disconnect the inlet harness.
3. Remove the 2 screws (B), ground harness and AC switch unit.
4. Remove the 2 wing bolts to release the elite Panaboard from the stand.
5. Remove the 3 screws (C) and control - power cover back.
6. Remove the 3 screws (D) and AC inlet assembly
5. Remove the 3 screws (C) and control - power cover back.
6. Remove the 3 screws (D) and AC inlet assembly
44
UB-T780
6.5.
Electronic Pen
1.
Remove the battery cover.
2.
Remove the battery.
3.
Remove the screw.
4.
Separate the cover from the base cover while pushing the base cover as shown in the following figure.
5.
Remove the penpoint from the penpoint shaft.
6.
Remove the film cover and penpoint shaft.
Click on the first or last page to see other UB-T780 service manuals if exist.