Panasonic UB-5838C / UB-5338C Service Manual ▷ View online
17
3.3.2.
Included Accessories
The package includes the parts for setting up the unit shown below. Make sure that all of these parts are included in the package
before proceeding.
before proceeding.
18
3.3.3.
Preparation
Note:
Make sure that the cushioning material and other packing
materials do not strike the screen film. (Contact may
damage the screen film.)
materials do not strike the screen film. (Contact may
damage the screen film.)
1.
Collapse the shipping box.
2.
Remove the protective plastic bag and lay down the unit onto the
shipping box with the screen film surface facing downward.
shipping box with the screen film surface facing downward.
19
3.3.4.
Installing Panaboard on a wall
Note:
To remove the rivets, turn them counterclockwise with a
screwdriver. (The fixed part of the rivets will be raised.)
screwdriver. (The fixed part of the rivets will be raised.)
Note:
Ensure that the shafts fall into the grooves of the
Wall-mounting Fixtures. If the shafts do not fit to the
grooves, adjust the position of the Wall-mounting Fixtures.
Wall-mounting Fixtures. If the shafts do not fit to the
grooves, adjust the position of the Wall-mounting Fixtures.
Note:
The 4 Wall-mounting screws are not included with the elec-
tronic board. Please purchase M6-size screws appropriate
for your wall.
tronic board. Please purchase M6-size screws appropriate
for your wall.
1.
Remove the 4 rivets.
2.
Hang the 2 Wall-mounting Shafts of the unit to the Wall-mounting
Fixtures.
Fixtures.
3.
Unscrew the 4 screws to remove the Cover Lower Assy.
4.
Fasten the wall-mounting clasps of the unit securely to the wall
with the 4 appropriate Wall-mounting screws.
with the 4 appropriate Wall-mounting screws.
5.
Attach the Cover Lower Assy. again.
20
3.3.5.
Installing Panaboard to the optional Stand
Note:
1. Use the washers included with the electronic board. Do
not use the washers included with Stand.
2. Do not tighten the screws too much. This may deform the
Stand.
3. By tightening the two screws with washers through holes
A and B, the unit will be positioned 100 mm (3 15/16")
higher than normal height (1,930 mm [6' 4"]).
higher than normal height (1,930 mm [6' 4"]).
1.
Attach the optional Stand to the unit.
• Each Stand has 3 holes (A, B, C).
1) Attach the Stand to the unit with the locking caster up.
2) When attaching the unit to the Stand at normal height (1,830
mm [6' 2/32"]), tighten the 2 screws (included in the Stand) with
washers using the hexagonal wrench through holes A and C.
2) When attaching the unit to the Stand at normal height (1,830
mm [6' 2/32"]), tighten the 2 screws (included in the Stand) with
washers using the hexagonal wrench through holes A and C.
2.
Stand the unit up.
3.
Attach the rivets (included in the Stand) to the holes in the Stand
that are not already in use.
that are not already in use.
• Normal height: 2 places
• Higher than normal height: 4 places
• Higher than normal height: 4 places
4.
Attach the clamp for the Power Cord to the upper side of the
Stand on the control box side.
Stand on the control box side.
Click on the first or last page to see other UB-5838C / UB-5338C service manuals if exist.