Panasonic UB-5335 / UB-5835 (serv.man2) Service Manual ▷ View online
21
4.6.2.
Attaching the Screen Unit
(1) Put the screen unit to the Board Attachment Upper (A1) fixed
to the wall, or the unit to the Panaboard‘s Stand.
• Put the Cover Left and Cover Right at both ends of screen unit
and put them on the Board Attachment Upper (A1) on the
screen unit as shown in the figure. Then, slide the screen unit
to the end of the groove in the direction of the arrow.
screen unit as shown in the figure. Then, slide the screen unit
to the end of the groove in the direction of the arrow.
Note:
The stand (option) height must be adjusted to the lowest
position before putting the Screen Unit. (For adjustment
of height, refer to 4.6.6.)
position before putting the Screen Unit. (For adjustment
of height, refer to 4.6.6.)
(2) Remove the 2 wing bolts.
• Remove the 2 wing bolts to release the folded screen portion.
(3) Spread the screen.
• Open the center panel and the right panel of the screen in the
direction of the arrow, then remove the cushions.
Note:
Do not touch the screen surface as doing so may damage
it.
it.
22
(4) Remove the hooks between the panels of the screen.
• Remove the hook connecting the center panel and the right
panel. Next, remove the cushion at the back of the screen unit.
Then, spread the screen unit.
Then, spread the screen unit.
Note:
Do not touch the screen surface as doing so may damage
it.
it.
(5) Hang the hook on the screen right to Board Attachment Upper
(A1).
23
4.6.3.
Removing the Corner Cover RL
(6) Tighten the screws of the screen unit (screws S1, washers
W1, spacers SP1, six each, and two screws S2).
(1) Remove a screw (f) fixing the Cover Right.
(2) Remove 2 screws (f) and a screw (d) that secure the Corner
Cover RL.
(3) Fix the attached Corner Cover RL (C3) to the Panaboard with
2 screws (f) and a screw (d).
(4) Fix the Cover Right with a screw (f).
(5) Attach the Labels (L) on the screws (f) at two locations.
24
4.6.4.
Removing the Folding Support (Front)
4.6.5.
Attaching the Cover Upper
4.6.6.
Adjusting the Height of the Screen Unit (Only for use of the optional Stand)
(1) Remove a screw and the Folding Support (Front).
(1) Put the Cover Upper (C1) in direction of the arrow and tighten
the screw (e) (S3) to fix it.
(1) Loosen the 4 height adjustment handles.
(2) Put the step frame (attached to the stand) to the center of the
reinforcement pipe so that the Screen Unit and the Stand do
not rise at the same time, then lift the Board Attachment
Lower (A2).
not rise at the same time, then lift the Board Attachment
Lower (A2).
Note:
After locking the caster of the stand, be sure to lift the
center of the Board Attachment Lower (A2) while stepping
on the step frame.
(Otherwise, it may be difficult to lift up and down it
smoothly)
center of the Board Attachment Lower (A2) while stepping
on the step frame.
(Otherwise, it may be difficult to lift up and down it
smoothly)
Click on the first or last page to see other UB-5335 / UB-5835 (serv.man2) service manuals if exist.