Panasonic UB-5335 / UB-5835 (serv.man2) Service Manual ▷ View online
25
(3) Check that the screws on both sides of the slide plate are put
on the slots at the same height (A, B, or C), then tighten the
height adjustment handles.
height adjustment handles.
Note:
When the Board Attachment Frame is located at the low-
est position, the Printer Unit cannot be attached to the
Board Attachment (Lower). In this case, lift up the frame
to slide it to a higher position.
est position, the Printer Unit cannot be attached to the
Board Attachment (Lower). In this case, lift up the frame
to slide it to a higher position.
(4) Attach the screw and the washer (included in the Stand sold
separately) so as to prevent the user from adjusting the
screen height at the lowest position by mistake.
screen height at the lowest position by mistake.
26
4.6.7.
Attaching the Printer Unit
(1) Hang the hook of the Printer Unit to 4 square holes at the left
on the Board Attachment Lower (A2).
Note:
When attaching the Printer Unit, take care that the printer
cables are not caught between the Board Attachment
Lower and the Printer Unit.
cables are not caught between the Board Attachment
Lower and the Printer Unit.
27
(2) Fix the Printer Unit to the Board Attachment Lower.
• For mounting on the wall: Use 2 screws (c) (S2).
• For installing to the stand: Use 4 screws (c) (S2).
• For installing to the stand: Use 4 screws (c) (S2).
28
4.6.8.
Attaching the Tray
(3) Connect the 2 connectors to the Screen Unit.
(4) Push down the Printer Open Lever to open the Printer Door.
(5) Remove the tape.
(6) Close the Printer Door.
(1) Fix one side of the plate (PL) to the bottom of the tray (C2)
with a screw (a) (S4).
Click on the first or last page to see other UB-5335 / UB-5835 (serv.man2) service manuals if exist.