Panasonic UB-5315SERIES / UB-5815SERIES (serv.man2) Service Manual ▷ View online
This assembling procedure is as follows in detail.
Step A: Attach the Fixing Plates (No.8) to the Board Attachment Frame.
Step B: Place the screws with the Board Attachment Frame in the grooves of the Side Pipes.
Step C: Insert the screws (No.11) into the Side Pipes (No.5) from the inside.
Step D: Install and fix the Height Adjustment Handles (No.12).
Step E: Fix the caps (No.14) to the Side Pipes.
Note:
Be sure to store the Wrench (No.17) on the back of the Cover (Lower).
33
UB-5315 SERIES / UB-5815 SERIES
4.9. Adjust Screen Unit Height on the Stand
This optional Stand has 4 level height locations of the Screen Unit from 1500mm (59.1”) to 2000mm (78.7”) based on the floor.
The following is the procedure how to change the height.
1. Loosen the 4 Height Adjustment Handles.
2. Hang the Step Frame (No.15) on the center of the Reinforcement Pipe (No.2) not to lift up the Stand with the Screen Unit.
Note:
Be sure to lift up Board Attachment (Lower), while holding it at the center securely and stepping on the Step Frame from the
back side after locking casters. Otherwise, it may be difficult to lift up and down it smoothly.
back side after locking casters. Otherwise, it may be difficult to lift up and down it smoothly.
34
UB-5315 SERIES / UB-5815 SERIES
3. Hang the Screw (No.11) to the slots in the Slide Plates to adjust the height, convenient for you.
And tighten 4 handles after confirming the screws on the both sides of the Fixing Plates hang in the same height slot.
Note:
The Printer Unit cannot be attached to the Board Attachment (Lower) or detached from its attachment when the Board
Attachment Frame is located at the lowest position. In this case, lift up the frame to slide it to a higher position.
Attachment Frame is located at the lowest position. In this case, lift up the frame to slide it to a higher position.
4. Attach the Screw (No.10) to prevent the user from adjusting the screen height at the lowest position by mistake.
35
UB-5315 SERIES / UB-5815 SERIES
4.10. Assembling the Wall-mounting Fixture
To install Panaboard to a wall, Panaboard accessories Wall-mounting Fixture (Upper), Wall-mounting Fixture (Lower), and Wall-
mounting Template are required for the Wall-mounting. The procedure is as follows.
mounting Template are required for the Wall-mounting. The procedure is as follows.
1. Confirm the wall is strong enough to support the weight of the Panaboard.
Caution:
The wall must be capable of supporting at least
784N [80kgf (176lbs.)] for UB-5315 Series
931N [95kgf (209lbs.)] for UB-5815 Series
2. Tape the Wall-mounting Template to the wall horizontally.
3. Drill holes in the wall for the Wall-mounting Fixtures.
4. After removing the Wall-mounting Template, attach the Wall-mounting Fixture (Upper) and Wall-mounting Fixture (Lower) with
the appropriate wall-mounting hardware.
36
UB-5315 SERIES / UB-5815 SERIES
Updated. See Supplement-1
Click on the first or last page to see other UB-5315SERIES / UB-5815SERIES (serv.man2) service manuals if exist.