Panasonic UB-5315SERIES / UB-5815SERIES (serv.man2) Service Manual ▷ View online
4.4.17. Attach the Cover (Upper).
When attaching the Cover (Upper), align it with the guides of the Corner Cover RU and Corner Cover LU, and lift it up in the
direction of the arrow.
direction of the arrow.
Note:
After attaching the Cover (Upper), store the Wrench in the compartment on the top of the Printer Unit (Position (A)) this section
procedure "4.4.7" mentions.
procedure "4.4.7" mentions.
21
UB-5315 SERIES / UB-5815 SERIES
4.4.18. Attach the Cover (Lower).
When attaching the Cover (Lower), align it with the guides of Corner Cover RL and Corner Cover LL in the direction of the arrow
(1), and lower it in the direction of the arrow (2) until it clicks into place. And fix cover with the wing bolt.
(1), and lower it in the direction of the arrow (2) until it clicks into place. And fix cover with the wing bolt.
4.4.19. Attach the accessory Power Cord to the AC Inlet.
4.4.20. Fit the Power Cord into the Cord Holder.
22
UB-5315 SERIES / UB-5815 SERIES
Updated. See Supplement-1
4.4.21. Attach the Rear Cover. (For Optional Stand Only)
· After peeling off the cover sheets of the adhesive tape, attach the Rear Cover to the Board Attachments (Upper / Lower) while
matching the top edges of them. Then install the rivets.
Note:
Rear Cover and Rivets are included in the optional Stand.
4.4.22. Adjust the Screen height, as required (Only for use of the optional Stand)
referring to 4.9.
4.4.23. Wipe the Screen surface.
Gently wipe the screen with a water-dampened cloth that has been thoroughly wrung.
Note:
1. Use a neutral kitchen cleaner diluted with water for hard-to-clean stains. (If you accidentally write on the screen
with an oil-based marker, wipe with a small amount of ethyl alcohol.)
2. Do not use thinner, benzene, or cleaners containing abrasives as this may result in discoloration.
3. Do not wipe the screen with a dry cloth as this may generate a static charge.
23
UB-5315 SERIES / UB-5815 SERIES
Install the Thermal Transfer Film in the Printer Unit as follows.
4.5. Installation-2 (Thermal Transfer Film)
4.5.1. Set the Power Switch to ON (|).
Confirm "
" will flash on the "Multi-copy / Error Indicator".
4.5.2. Push down the Printer Open Lever to open the Printer Door.
4.5.3. After inserting the Axis (Blue) into the left side´s slot in the outer position to put
up in the axis, attach the Blue Gear on the right side, so that its gear matches
with the gear in lower side.
with the gear in lower side.
24
UB-5315 SERIES / UB-5815 SERIES
Click on the first or last page to see other UB-5315SERIES / UB-5815SERIES (serv.man2) service manuals if exist.