DOWNLOAD Panasonic KV-S5076H / KV-S5046H Service Manual ↓ Size: 36.94 MB | Pages: 127 in PDF or view online for FREE

77

1. Remove the Left Cover. (See 8.5.10.)

2. Disconnect the 6 connectors.

3. Remove the 2 screws on the USR RELAY Board.

1. Remove the Left Cover. (See 8.5.10.)

2. Loosen the 2 screws. Push down the lever until the belt goes
    slack, and then tighten the screws to hold the lever in place.

3. Remove the Drive Belt.

a. Reattach the Drive Belt as shown in the following figure.
b. Loosen the 2 screws. (Loosening the 2 screws will make
    the belt tighten properly.)
c. Tighten the 2 screws.

78

1. Push the ADF Door Release to open the ADF Door.

2. Open and remove the Double-feed Prevention Cover.

3. While releasing the claw (1), remove the Double-feed 
    Prevention Roller (2).

4. Remove the Double-feed Prevention Roller rubber parts.

79

5. Pull in each directions, and remove rubber parts.

6. Component Parts.

80

1. Remove the Double-feed Prevention Roller. (See 8.5.13.)

2. Remove the Hopper Motor. (See 8.5.9.)

3. Remove 2 screws and release 3 claws and remove 
    Hopper Base cover.

4. While releasing the 3 claws on the bottom of Hopper Plate
    Assembly and pushing down the top of the Gate, pull and
    remove the assembly forward.

   (1) While pull the Hopper Plate Assembly forward, release 
        the 3 claws (Claw1).
   (2) While pull the Hopper Plate Assembly upward, release
        the 2 hooks to remove the assembly.

5. Lift up the Hopper plate.