Panasonic EP-1270-W0 Service Manual ▷ View online
ORDER NO.HPD0511W28C0
- 9 -
6. Display method of massage block total use time
Total use time
While pushing the + and the – speed adjustment bottons simultaneously, turn on the power switch and continue
to hold the buttons for approximately 3 seconds. Release after the LED lights up.
Time (hour)
LED A
5
LED B
10
LED C
20
LED D
40
LED E
80
LED F
160
LED G
320
LED H
640
LED I
1,280
LED J
2,560
Chart for reading each function use time
Push the button.
LED lights.
Use time
knead
K
knead + swedish
compression
L
compression + hawaiian
swedish M
massage
motor
regional roll
N
up/down motor
tap tap
tapping
motor
leg massage
leg massage
leg air massage
reclining uo
O
reclining lift motor
ottoman up
P
ottoman lift motor
*When replacing the Main Circuit PCB, the use time is counted to zero because the use time is memorized in Main Circuit
PCB.
*When pushing on/off button, the operation returns to normal mode.
Display method
Display it by utilizing LEDs of Controller.
e.g. In the above case, 640 (LED H) + 5 (LED A) = 645 hours.
It is possible to indicate up to 5,115 hours.
To read the each operation function, push the following buttons after reading the
total use time.
You can read the each operation function use time as the same display method of
total use time.
- 10 -
7 DISASSEMBLY AND ASSEMBLY INSTRUCTION
(COSMETIC PART AND CHAIR CONSTRUCTION)
7.1. Removing the Head rest, Back rest cushion, Arm rest
1. Unzip the zippers and remove the Back cushion with
pillow.
2. Remove four Push-turn rivets on each sides and remove the
Side covers.
3. Insert a screwdriver and unlock the lock and fall the
Upper main body forward.
* Be careful that the Upper main body may fall forward
suddenly.
- 11 -
4. Unscrew two screws on each outer sides, and remove the
Velcro tape on each inner sides and uncsrew one screw
with washers.
After unscrewing screws on inner sides, lift the Upper main
body to the original position.
5. Pull out the Armrest.
6. Remove two long screws with washers (A) and one short
screw with a washer (B).
And pull out the Armrest top.
- 12 -
7. Unscrew one screw with washers and peel off the Velcro
tape.
* When you zip the Zippers, tuck in the metal of the
zippers under the cloth
8. Peel off the Velcro tapes (A) and remove seven
Brushclips (B).
9. Unscrew five Push-turn rivets and remove the Under
cover.
10. Pull out the Zipper end and the cut the Insulated tie and
unzip the Zippers.
Unscrew five Push-turn rivets (A) and unhook the Hook
(B).
Click on the first or last page to see other EP-1270-W0 service manuals if exist.