Panasonic EP-1270-W0 Service Manual ▷ View online
- 13 -
11. Insert a slotted screwdriver, etc into the hole (A) and push it
to unhook the Hook.
Unscrew a Push-turn rivet on each sides.
Then, you can remove the Seat.
7.2. Removing the Massage mechanism block
1.
Insert a screwdriver and unlock the lock and fall the
Upper main body forward.
* Be careful that the Upper main body may fall forward
suddenly.
* It will be convenient if you fall the Upper main body
forward to work on the Massage mechanism block.
* If you has removed the Seat, put it back on the Frame.
Otherwise, the Massage wheel cover may get scratched.
2.
Unscrew four screws.
3.
Unscrew the screw for the Ground wire and the screw for
the Fitting and the take off the Cover clip and remove the
Connecting cord for the Main PCB.
- 14 -
7.3. Removing the parts of the Massage mechanism block
1.
Take off the Spring (A).
Turn the both ends of the Tapping shaft anticlockwise with
spnanners.
After a bolt with a washer on one side is removed,
insert a bar, etc. into the hole (B) to hold and turn the
Spanner again to remove the other bolt.
The bolts are locked wih glue. When assembling them,
use the prroper glue.
Unscrew the Nut (C).
Then, you can take off the Arm block.
2.
Unscrew six screws with nuts (A).
Unscrew one screw with nuts (B).
Unscrew one nut (C) with a bolt.
Take off the Spring (D).
Unscrew one screw with a nut.
3.
Unscrew two screws with a wahser and a nut on the
Connection link.
Unscrew two screws with a washer.
- 15 -
4.
Take off the Tapping belt and the Pulley.
5.
Unscrew two screws on the Sensor plate.
Unscrew one screw from each Sensor.
6.
Unscrew four screws and remove the Tapping motor.
- 16 -
7.
Unscrew three screws and remove the Up/down sensor
block.
Unscrew one screw from the UP/down sensor block and
remove the Up/down sensor.
8.
Unscrew two screws from the Connection PCB (A) and
remove the Connection PCB.
Unscrew two screws from the Connection PCB board (B)
and remove the Connection PCB board.
9.
Unscrew seven screws on the Massage mechanism block
cover with a small screwdriver and remove the Massage
mechansim block cover.
10. Unscrew four screws and remove the Massage gear
block.
Click on the first or last page to see other EP-1270-W0 service manuals if exist.