Panasonic CR14C Service Manual ▷ View online
Note: Ensure 4 springs in place.
Step 18: Tilt and slot the traverse unit onto the middle chassis.
Step 19: Ensure both catches are hooked.
Step 20: Fix 4 fixed pins.
45
CR14C
Step 21: Fix switch rod, ensure the switch rod’s guide seat
properly onto the groove.
properly onto the groove.
• Assembly of Traverse Unit Assy
Step 22: Slide TRV slide plate assy to the end.
Step 23: Turn over the UD base, release catch and push the
guide of the TRV slide plate as arrows shown.
guide of the TRV slide plate as arrows shown.
Step 24: Ensure both grooves are open.
Step 25: Ensure the OPU sub rack is below the guide line.
46
CR14C
Step 26: Slot the traverse unit assy onto the UD base as arrow
shown.
shown.
Note: Ensure the bosses fix exactly onto the guides.
Step 27: Push the guide to lock the traverse unit assy in.
• Assembly of Change arm
Step 28: Insert service jig into the traverse hole, rotate the gear
clockwise.
clockwise.
Note: Ensure the groove of the TRV slide plate assy stop at the
position shown.
position shown.
Step 29: Install the change arm to the groove of the TRV slide
plate assy.
plate assy.
47
CR14C
Step 30: Push the TRV slide plate assy as arrow shown to lock
the change arm.
the change arm.
• Assembly of Clamp Plate Assy
Step 31: Fix the clamp plate assy align to both guides, make
sure the catch is fully catched.
sure the catch is fully catched.
• Assembly of Tray Stoppers
Step 32: Fix the tray stoppers.
10.3.2. Assembly of Mecha Base Unit
Parts
• Assembly of Mecha P.C.B. and Sensor P.C.B.
Step 1: Align the component of Mecha P.C.B. to the groove.
48
CR14C
Click on the first or last page to see other CR14C service manuals if exist.