Panasonic CR14 Service Manual ▷ View online
Step 22: Slot the traverse unit assy onto the UD base as arrow
shown.
shown.
Note: Ensure the bosses fix exactly onto the guides.
Step 23: Push the guide to lock the traverse unit assy in.
• Assembly of Change arm
Step 24: Insert service jig into the traverse hole, rotate the gear
clockwise.
clockwise.
Note: Ensure the groove of the TRV slide plate assy stop at the
position shown.
position shown.
Step 25: Install the change arm to the groove of the TRV slide
plate assy.
plate assy.
Step 26: Push the TRV slide plate assy as arrow shown to lock
the change arm.
the change arm.
45
CR14
• Assembly of Clamp Plate Assy
Step 27: Fix the clamp plate assy align to both guides, make
sure the catch is fully catched.
sure the catch is fully catched.
• Assembly of Tray Stoppers
Step 28: Fix the tray stoppers.
10.3.2. Assembly of Mecha Base Unit
Parts
• Assembly of Mecha P.C.B. and Sensor P.C.B.
Step 1: Align the component of Mecha P.C.B. to the groove.
46
CR14
Step 2: Ensure all catches are hooked to the Mecha P.C.B. and
Sensor P.C.B. then fix 2 screws.
Sensor P.C.B. then fix 2 screws.
• Assembly of Open Switch Lever
Step 3: Install open SW lever.
• Assembly of All Trigger Lever
Step 4: Ensure all trigger lever’s boss seated properly onto the
groove.
groove.
Step 5: Ensure the “U” shape of the all trigger lever snap to the
boss.
boss.
47
CR14
• Assembly of Trigger Slider Assy
Step 6: Combine both trigger slider and trigger lever.
Step 7: Ensure trigger lever’s ribs seated properly onto the
grooves.
grooves.
Caution:
Do not exert force as it may cause damage to the trigger
lever.
lever.
Step 8: Install trigger slider assy, make sure the grooves fix
exactly onto the guides.
exactly onto the guides.
Step 9: Slide the trigger slider assy.
48
CR14
Click on the first or last page to see other CR14 service manuals if exist.