Panasonic CR14 Service Manual ▷ View online
10.3. Assembling of Mechanism
Unit
10.3.1. Assembly of UD Base Unit Parts
• Assembly of Load Plate
Step 1: Install load plate.
• Assembly of TRV Slide Plate Assy
Step 2: Attach the TRV slide plate to the sub slide plate.
Step 3: Slide the TRV slide plate until it stop.
Step 4: Slide the load plate until it stop.
Step 5: Install TRV slide plate assy align to groove and guide of
the UD base.
the UD base.
Step 6: Ensure the boss seated properly onto the groove.
41
CR14
• Assembly of Load Lever
Step 7: Push as arrow shown to ensure the boss seated on
point (A).
point (A).
Step 8: Ensure both bosses align.
Step 9: Install load lever as shown, make sure the catch is fully
catched.
catched.
• Assembly of Switch Slider
Step 10: Push the guide until it stop.
Step 11: Fix the switch slider to the catches.
Note: Ensure the switch slider spring is fixed at the back of the
switch slider.
switch slider.
Step 12: Press down the switch slider and make sure it is fully
catched onto the UD base.
catched onto the UD base.
42
CR14
• Assembly of Play Pinion
Step 13: Install the play pinion and press down.
• Assembly of Traverse Unit
Step 14: Fix 4 floating rubbers.
Step 15: Tilt and slot the Traverse unit onto the middle chassis.
Note: Ensure the boss fix exactly under the middle chassis’s
guide.
guide.
Step 16: Fix 2 fixed pins.
43
CR14
Step 17: Fix Switch rod, ensure the switch rod’s guide seat
properly onto the groove.
properly onto the groove.
• Assembly of Traverse Unit Assy
Step 18: Slide TRV slide plate assy to the end.
Step 19: Turn over the UD base, release catch and push the
guide of the TRV slide plate as arrows shown.
guide of the TRV slide plate as arrows shown.
Step 20: Ensure both grooves are open.
Step 21: Ensure the OPU sub rack is below the guide line.
44
CR14
Click on the first or last page to see other CR14 service manuals if exist.