Panasonic CR14 Service Manual ▷ View online
10.1.2. Assembly of Traverse Unit Assy
Step 1: Slot the traverse unit assy into the guides as arrow
shown.
shown.
Note: Ensure the bosses fix exactly onto the guides.
Step 2: Place down the traverse unit assy.
Step 3: Fix the FFC wires by using the adhesive tapes.
Step 4: Release the catch and push the guide as arrows shown
to close both grooves.
to close both grooves.
25
CR14
10.2. Disassembling of Mechanism
Unit in “UD” Position
Note: Mechanism unit (CR14) reliability test can be carried out
in complete unit or using the Reliability P.C.B (Refer to section
8).
in complete unit or using the Reliability P.C.B (Refer to section
8).
10.2.1. Disassembly of UD Base Unit
Step 1: Press both claws at the sides as arrows shown and
push the top cover backwards.
push the top cover backwards.
Step 2: Remove the top cover as arrows shown to release the
tray stoppers.
tray stoppers.
Step 3: Use a flathead screwdriver to remove OC spring.
Note: Ensure the OC spring is handle properly and keep it in a
safe place.
safe place.
Step 4: Remove OC gear assy as arrows shown.
Note: Ensure the OC gear assy is handle properly and keep it
in a safe place.
in a safe place.
26
CR14
Step 5: Use a flathead screwdriver slot into the gap and push
out the tray lock lever as arrows shown.
out the tray lock lever as arrows shown.
Step 6: Push the trays towards the front as arrow shown.
Step 7: Push the catch and slide the UD cam R guide as arrows
shown.
shown.
Step 8: Turn over the unit and detach the FFC wires from the
adhesive areas.
adhesive areas.
27
CR14
Step 9: Lift up the UD base unit.
Step 10: Release the change arm.
Step 11: Remove the UD base unit as arrow shown.
10.2.2. Disassembly of Trays
• Follow (Step 1) to (Step 11) in item 10.2.1.
Step 1: Push the trays as arrow shown until they stop (bottom
picture).
picture).
Step 2: Tilt the trays towards one side as arrow shown.
Step 3: Lift and remove the trays as arrows shown.
28
CR14
Click on the first or last page to see other CR14 service manuals if exist.