Panasonic CR14 Service Manual ▷ View online
9.2.1. Manually set to “UD” position
Step 1: Check any missing tray at the mechanism front.
Caution:
The missing tray is engaged in the play position.
Step 2: Press both claws at the sides as arrows shown and
push the top cover backwards.
push the top cover backwards.
Step 3: Remove the top cover as arrows shown to release the
tray stoppers.
tray stoppers.
Step 4: Insert service jig into the loading hole, rotate the gear
counter clockwise.
counter clockwise.
17
CR14
Step 5: Rotate the gear to “Load/upload” position.
Step 6: Insert service jig into the traverse hole, rotate the gear
clockwise.
clockwise.
Step 7: Rotate the gear to “Mode” position.
Step 8: Insert service jig into the loading hole, rotate the gear
clockwise.
clockwise.
18
CR14
Step 9: Rotate the gear to “Up/down” position.
Step 10: Insert service jig into the traverse hole, rotate the gear
clockwise.
clockwise.
Step 11: Rotate the gear to “Load/upload” position.
Step 12: Insert service jig into the loading hole, rotate the gear
19
CR14
clockwise until both bosses positioned at the top of the UD cam
R guide.
R guide.
Step 13: Insert service jig into the traverse hole, rotate the gear
counter clockwise.
counter clockwise.
Step 14: Rotate the gear to “Mode” position.
Step 15: Attach the top cover to the tray stoppers.
Step 16: Slide the top cover as arrow shown.
Note: Ensure both claws are catched.
(Refer to Section 10.2 for disassembling of Mechanism
unit.)
unit.)
20
CR14
Click on the first or last page to see other CR14 service manuals if exist.