Panasonic CR14 Service Manual ▷ View online
8.2. Jig’s Flow Diagram
13
CR14
8.2.1. Flow operation
14
CR14
15
CR14
9.1. Using Service Modes (Main
Unit)
9.1.1. In Service Mode 1
Purpose:
All trays in “STOCK” position, UD base unit at tray 5
position.
position.
Refer to Section 10.2 for disassembling of Mechanism
unit.
unit.
Procedures:
• Press and hold “STOP” button followed by “FORWARD”
• Press and hold “STOP” button followed by “FORWARD”
button to enter TEST mode.
• Press [1] button on main unit to enter Service Mode 1.
9.1.2. In Service Mode 2
Purpose:
In “PLAY” position, OPU at the centre position (see section
6.3 for more information).
6.3 for more information).
Refer to Section 10.1 for disassembling of Traverse unit
assy.
assy.
Procedures:
• Press and hold “STOP” button followed by “FORWARD”
• Press and hold “STOP” button followed by “FORWARD”
button to enter TEST mode.
• Press [2] button on main unit to enter Service Mode 2.
9.2. Using Manually
• Preparation of service jig
- This unit has two gears which are used for checking items
(open/close of tray, up/down operation of traverse unit by
manually) when servicing. (For gear information, that is
described on the items for disassembly procedures.)
(open/close of tray, up/down operation of traverse unit by
manually) when servicing. (For gear information, that is
described on the items for disassembly procedures.)
- For preparation of gear (for servicing), perform the
procedures as follows.
procedures as follows.
- In case of re-servicing the same set, the “gear for
servicing” may be took off because it had been used. So,
the “gear for servicing” must be stored.
servicing” may be took off because it had been used. So,
the “gear for servicing” must be stored.
Step 1: Cut the gear out from the top cover.
Note: The bigger gear is for loading hole and the smaller gear
is for traverse hole.
is for traverse hole.
Step 2: Insert the gear into the hexagonal wrench.
9 Before Disassembly
16
CR14
Click on the first or last page to see other CR14 service manuals if exist.