LG F1232RDSW Service Manual ▷ View online
33
CABINET COVER ASSEMBLY
Unscrew the 4 screws from upper of the cabinet.
Unscrew the screw from filter cover.
Put a flat driver into the both sides of the filter
cover, and pull it out
cover, and pull it out
Unscrew the screw from the lower side of the
cabinet cover.
cabinet cover.
34
Open the door.
Disassemble the clamp assembly by using the
gasket clammp plier(383EER4001) and then put
gasket assmebly into drum
Disassemble the clamp assembly by using the
gasket clammp plier(383EER4001) and then put
gasket assmebly into drum
Disassemble 2 screws from the Door Lock
Disconnect the wiring connected to holder and
connector of the Door S/W
Disconnect the wiring connected to holder and
connector of the Door S/W
NOTE
1. When assembling the CABINET COVER,
connect the connector
2. When connecting the CONNECTOR
ASSEMBLY and Door S/W, assemble
under the door switch.
under the door switch.
35
DOOR ASSEMBLY
DOOR LOCK SWITCH ASSEMBLY
Open the door.
Remove the two screws from the Hinge
after lifting the door assembly upward, and
assemble it.
Remove the two screws from the Hinge
after lifting the door assembly upward, and
assemble it.
Open the door and disassemble the CLAMP
ASSEMBLY.
ASSEMBLY.
Unscrew the 2 screws.
Be careful!
The door is heavy.
NOTE
Reconnect the connector after replacing the
DOOR SWITCH ASSEMBLY.
DOOR SWITCH ASSEMBLY.
36
PUMP
HEATER
THERMISTOR
Disassemble the cabinet cover.
Separate the pump hose, the bellows
and the circulation hose assembly from the
pump assembly.
and the circulation hose assembly from the
pump assembly.
Disassemble the pump assembly in arrow
direction.
direction.
Disassemble the back cover.
Separate 3 connectors connected to Heater
Assembly
Assembly
Loosen the M10 nut of Heater ASSY center and
pull out the heater
pull out the heater
Disassemble the cabinet cover.
Unplug the white connector from the thermistor.
Pull it out by holding the bracket of the
thermistor.
NOTE
When assembling the heater, insert the
heater into the bracket heater on the bottom of
the tub, tighten completely the M10 nut so the
heater is secure
heater into the bracket heater on the bottom of
the tub, tighten completely the M10 nut so the
heater is secure
after assembling the heater, please check it by
hand (you can hear the sound if the heater
doesn’t assemble well)
hand (you can hear the sound if the heater
doesn’t assemble well)
Click on the first or last page to see other F1232RDSW service manuals if exist.