JBL ON STAGE 200ID EMC - CB Certificate ▷ View online
- Page 4 of 63 -
Report
No.
98323
TRF No. IECEN60950_1C
Test item particulars
.................................................. :
Equipment mobility .................................................... :
movable
hand-held
stationary
fixed
Connection to the mains ........................................... :
pluggable equipment
direct plug-in
permanent connection
for building-in
Operating condition ................................................... :
continuous
short-time
intermittent
Over voltage category .............................................. :
OVC I
OVC II
OVC III
OVC IV
Mains supply tolerance (%)....................................... : N/A
Tested for IT power systems .................................... :
Tested for IT power systems .................................... :
Yes
No
IT testing, phase-phase voltage (V) ......................... : N/A
Class of equipment ................................................... :
Class of equipment ................................................... :
Class I
Class II
Class III
Not classified
Mass of equipment (kg)............................................. : Weight: 0.63 kg
Dimension: 360mm x 113mm x 65.8mm
Pollution degree ....................................................... :
PD 2
PD 3
IP protection class .................................................... : IP20
Measuring instrument
Inv. no.
Date
Possible test case verdicts:
- test case does not apply to the test object .................: N (N/A)
- test object does meet the requirement.......................: P (Pass)
- test object does not meet the requirement.................: F (Fail)
Testing
..........................................................................:
Date of receipt of test item ............................................: January 2008
Date(s) of performance of tests ....................................: January 2008
General remarks:
The test results presented in this report relate only to the object tested.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing laboratory.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing laboratory.
"(see Enclosure #)" refers to additional information appended to the report.
"(see appended table)" refers to a table appended to the report.
Throughout this report a
"(see appended table)" refers to a table appended to the report.
Throughout this report a
comma /
point is used as the decimal separator.
- Page 5 of 63 -
Report
No.
98323
TRF No. IECEN60950_1C
General product information:
The equipment under tests is a Class III computer speaker system with two mains speakers of 4ohm
The equipment under tests is a Class III computer speaker system with two mains speakers of 4ohm
powered by a detachable Limited Power Source adaptor with a non-specialized type connector. The
computer
speaker system is considered as IT product.
Normal operating condition: Supplied 1KHz sine wave for speakers in computer speaker system and obtain
1/8 Maximum non-clipped output power, & charging Ipod (500mA 5V)
Circuit characteristics: The equipment contains secondary (SELV).
Maximum recommended ambient (Tmra): 40°C
Connection to the supply: No connection to mains.
1.1.2 - Additional requirements:
Exposure to extreme temperatures, excessive dust, moisture or vibration; to flammable gases; to corrosive
or explosive atmospheres:
This equipment is intended to operate in a "normal" environment (Offices and homes).
Electromedical equipment connected to the patient:
This equipment is not an electromedical equipment intended to be physically connected to a patient.
Equipment used in vehicles, ships or aircrafts, in tropical countries, or at elevations > 2000m:
This equipment is intended to operate in a "normal" environment (Offices and homes).
Normal operating condition: Supplied 1KHz sine wave for speakers in computer speaker system and obtain
1/8 Maximum non-clipped output power, & charging Ipod (500mA 5V)
Circuit characteristics: The equipment contains secondary (SELV).
Maximum recommended ambient (Tmra): 40°C
Connection to the supply: No connection to mains.
1.1.2 - Additional requirements:
Exposure to extreme temperatures, excessive dust, moisture or vibration; to flammable gases; to corrosive
or explosive atmospheres:
This equipment is intended to operate in a "normal" environment (Offices and homes).
Electromedical equipment connected to the patient:
This equipment is not an electromedical equipment intended to be physically connected to a patient.
Equipment used in vehicles, ships or aircrafts, in tropical countries, or at elevations > 2000m:
This equipment is intended to operate in a "normal" environment (Offices and homes).
The product has been tested according to standard IEC 60950-1:2005 (2
nd
Edition) / EN 60950-1:2006
and those deviations taken into account of
CENELEC common modifications
United Kingdom
Canadian
Singapore
Finland
Denmark
Ireland
Korean
Chinese
Sweden
Germany
Spain
US
Japanese
Norway
Switzerland
Australian
Israeli
- Page 6 of 63 -
Report
No.
98323
TRF No. IECEN60950_1C
These tests fulfil the requirements of standard EN ISO/IEC 17025.
This test report includes the following documents:
Test report, pages ............. 63 Deviation list, pages .......
US differences
5
Deviation list, pages .......
Japanese differences
Japanese differences
7
Deviation list, pages ..........
Australian differences
Australian differences
8
Deviation list, page .........
Israeli differences
Israeli differences
1 Annexes,
page
................
(in test report)
--
Deviation list, pages ..........
Canadian differences
Canadian differences
5
Deviation list, pages .......
Singapore differences
Singapore differences
2 Photos, pages ..................
9
Deviation list, page ..........
Korean differences
Korean differences
1
Deviation list, page .........
Chinese differences
Chinese differences
1
List of used measuring instruments and other test devices, pages ...................................................
N
- Page 7 of 63 -
Report
No.
98323
IEC 60950-1:2005 / EN 60950-1:2006
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IECEN60950_1C
1 GENERAL
—
1.5 Components
—
1.5.1 General
—
Comply with IEC 60950 or relevant component
standard
standard
(see appended table 1.5.1)
P
1.5.2
Evaluation and testing of components
Certified components are used
in accordance with their
ratings, certifications and they
comply with applicable parts of
this standard.
Components not certified are
used in accordance with their
ratings and they comply with
applicable parts of IEC 60950-
1 and the relevant component
standard.
Components, for which no
relevant IEC-standard exists,
have been tested under the
conditions occurring in the
equipment, using applicable
parts of IEC 60950-1.
in accordance with their
ratings, certifications and they
comply with applicable parts of
this standard.
Components not certified are
used in accordance with their
ratings and they comply with
applicable parts of IEC 60950-
1 and the relevant component
standard.
Components, for which no
relevant IEC-standard exists,
have been tested under the
conditions occurring in the
equipment, using applicable
parts of IEC 60950-1.
P
1.5.3
Thermal controls
No thermal controls.
N
1.5.4 Transformers
Class III equipment to be
supplied by a separately
approved power supply with an
SELV output. Power supply not
evaluated. Refer to Summary of
Testing.
supplied by a separately
approved power supply with an
SELV output. Power supply not
evaluated. Refer to Summary of
Testing.
N
1.5.5
Interconnecting cables
The interconnecting cables
contain only SELV.
contain only SELV.
P
1.5.6
Capacitors bridging insulation
Class III equipment.
N
1.5.7
Resistors bridging insulation
Refer below:
—
1.5.7.1
Resistors bridging functional, basic or
supplementary insulation
supplementary insulation
No such component.
N
1.5.7.2
Resistors bridging double or reinforced insulation
between a.c. mains and other circuits
between a.c. mains and other circuits
No resistors bridging double or
reinforced insulation.
reinforced insulation.
N
1.5.7.3
Resistors bridging double or reinforced insulation
between a.c. mains and antenna or coaxial cable
between a.c. mains and antenna or coaxial cable
No resistors bridging double or
reinforced insulation.
reinforced insulation.
N
Click on the first or last page to see other ON STAGE 200ID service manuals if exist.