JBL ES 150PW (serv.man4) EMC - CB Certificate ▷ View online
ELECTRONICS TESTING CENTER(ETC), TAIWAN
File No. : 08-07-RBF-038-01
EMC TESTING DEPARTMENT II
Page: 32 / 42
4.2.1.2 Electrostatic Discharge Immunity Test Setup Photos :
ELECTRONICS TESTING CENTER(ETC), TAIWAN
File No. : 08-07-RBF-038-01
EMC TESTING DEPARTMENT II
Page: 33 / 42
4.2.2 RF Radiated Fields Immunity Test :
4.2.2.1 RF Radiated Fields Immunity Test Data:
Operating Conditions of The EUT : Operation Mode
Test Date : Jul. 08, 2008
Test Specification
EN 61000-4-3:2006
Equipment
Manufacturer
Model No.
Calibration Date
Next Cal. Date
Antenna
AR
AT5080
N/A
N/A
signal Generator
Aglient
E4421B
2007/07/04
2008/07/03
Amplifier Ophir 5172
N/A
N/A
Amplifier Ophir 5127
N/A
N/A
POWER METER
Booton
4232A 2007/07/04
2008/07/03
Climatic Condition
Ambient Temperature: 25 °C Relative
Humidity:
57 %RH
Power Supply System
AC Power : 230 Vac 50 Hz
Test Set-up
Floor-standing Equipment
EUT
Interfere source
Horizontal/Vertical
Frequency Range:
80 MHz ~ 2700 MHz Field
Strength:
3
V/m
Modulation (AM 1kHz 80%)
Sweep Rate
:
≤ 1.5×10-3 decades/s Step Size
:
≤ 1 % of preceding frequency value Dwell time
:
2.9 s
Frequency Range (MHz)
Antenna-Polarization
Direction of Device
Test Result
front A
rear A
left A
80-1000 1400-2700
Horizontal
right A
front A
rear A
left A
80-1000 1400-2700
Vertical
right A
Note : “ A ” means the EUT function was correct during the test.
ELECTRONICS TESTING CENTER(ETC), TAIWAN
File No. : 08-07-RBF-038-01
EMC TESTING DEPARTMENT II
Page: 34 / 42
4.2.2.2 RF Radiated Fields Immunity Test Setup Photos :
ELECTRONICS TESTING CENTER(ETC), TAIWAN
File No. : 08-07-RBF-038-01
EMC TESTING DEPARTMENT II
Page: 35 / 42
4.2.3 EFT/Burst Immunity Test :
4.2.3.1 EFT/Burst Immunity Test Data:
Operating Conditions of The EUT : Operation Mode
Test Date : Jun.02, 2008
Test Specification
EN 61000-4-4:2004
Equipment
Manufacturer
Model No.
Calibration Date
Next Cal. Date
EMC Immunity Tester
EMC-PARTNER
TRANSIENT-1000
2007/12/13
2008/12/12
Climatic Condition
Ambient Temperature: 23 °C Relative
Humidity:
51 %RH
Atmospheric Pressure : 990 mbar
Power Supply System
AC Power : 230 Vac 50 Hz
Test Set-up
Floor-standing Equipment
Pulse :5/50ns
Burst :15m/300ms
Repetition Rate: 5kHz
Test time: 1 min/each condition
1.0 kV
\Voltage\Polarity\
\Test Point\Mode\Result\
+ -
L B
B
Power Line
N B
B
L – N
B
B
Note : “ A ” means the EUT function was correct during the test.
“ B” means the EUT’s function was interrupted during the test. After test, the EUT
operate as intended without operator intervention.
Click on the first or last page to see other ES 150PW (serv.man4) service manuals if exist.