Harman Kardon AVR 151 (serv.man5) EMC - CB Certificate ▷ View online
Page 5 of 6
Report No.: 232173
ATTACHMENT 6
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
Table 8、
Table 9、
Table 10
Table 9、
Table 10
Bellow the headings of Table 8 Table 9 and Table
10 ,added :
“（Applicable for altitude up to 2000m）”
10 ,added :
“（Applicable for altitude up to 2000m）”
Noted
Amended Table 9 Note 2:
For operating voltage values exceeding of table 8,
extrapolation is permitted.
For operating voltage values exceeding of table 8,
extrapolation is permitted.
Noted
13.3.3
After the first paragraph, added a paragraph:
The requirements in table 10 apply to apparatus
intended to be used at altitude not exceeding 2 000
m. For apparatus intended to be operated at
altitudes between 2 000m and 5 000m , Minimum
CLEARANCE limits shall multiply with multiplication
factor 1.48 in table A.2 of GB/T 16935.1. For
apparatus intended to be operated at altitude more
than 5 000m , Minimum CLEARANCES limit shall
multiply with corresponding multiplication factor in
table A.2 of GB/T 16935.1.
The requirements in table 10 apply to apparatus
intended to be used at altitude not exceeding 2 000
m. For apparatus intended to be operated at
altitudes between 2 000m and 5 000m , Minimum
CLEARANCE limits shall multiply with multiplication
factor 1.48 in table A.2 of GB/T 16935.1. For
apparatus intended to be operated at altitude more
than 5 000m , Minimum CLEARANCES limit shall
multiply with corresponding multiplication factor in
table A.2 of GB/T 16935.1.
The apparatus intended to
be operated at altitudes up to
2 000m.
be operated at altitudes up to
2 000m.
N/A
15.1.1
After the first paragraph, added a paragraph:
Plugs connected to the MAINS in apparatus shall
comply with GB 1002 or GB 1003.
Plugs connected to the MAINS in apparatus shall
comply with GB 1002 or GB 1003.
Mains plug and appliance
couplers with cord complying
Chinese National and Industrial
standards provided, and see
couplers with cord complying
Chinese National and Industrial
standards provided, and see
also summary of testing.
P
18
Delete the first paragraph except the first sentence. N/A
18.1
Replaced contents of two dashes in the fourth
paragraph:
— for intrinsically protected tubes, including those
paragraph:
— for intrinsically protected tubes, including those
having integral protective screens, compliance
is checked according to GB27701.
— for tubes non-intrinsically protected checked by
18.2.
18.2.
N/A
18.2
Delete clause 18.2 and renumber the existing
clause 18.3 as 18.2.
clause 18.3 as 18.2.
N/A
Page 6 of 6
Report No.: 232173
ATTACHMENT 6
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
Annex J.6 After the first paragraph, added a paragraph:
For apparatus intended to be operated at altitudes
between 2 000m and 5 000m, the Minimum
CLEARANCES in table J.2 shall multiply with
multiplication factor 1.48 in table A.2 of GB/T
16935.1. For apparatus intended to be operated at
altitude more than 5 000m, Minimum
CLEARANCES shall multiply with corresponding
multiplication factor in table A.2 of GB/T 16935.1.
between 2 000m and 5 000m, the Minimum
CLEARANCES in table J.2 shall multiply with
multiplication factor 1.48 in table A.2 of GB/T
16935.1. For apparatus intended to be operated at
altitude more than 5 000m, Minimum
CLEARANCES shall multiply with corresponding
multiplication factor in table A.2 of GB/T 16935.1.
The apparatus intended to
be operated at altitudes up to
2 000m.
be operated at altitudes up to
2 000m.
N/A
Delete note 3 of table J.6.
Noted
Annex R
(normativ
e)
(normativ
e)
Added annex R:
Instructions for the new safety warning labels.
R.1 Altitude warning label
Instructions for the new safety warning labels.
R.1 Altitude warning label
Meaning of the label: Evaluation for apparatus only
based on altitude not exceeding 2000m, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used at altitude above
2000m .
R.2 Climate warning label
based on altitude not exceeding 2000m, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used at altitude above
2000m .
R.2 Climate warning label
Meaning of the label: Evaluation for apparatus only
based on temperate climate condition, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used in tropical climate
region.
based on temperate climate condition, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used in tropical climate
region.
The apparatus intended to
be operated at altitudes up to
2 000m, and a
be operated at altitudes up to
2 000m, and a
ppropriate
wording provided as follows,
See copy of marking plate
The apparatus intended to
be used in not tropical climate
regions, and a
be used in not tropical climate
regions, and a
ppropriate
wording provided as follows
See copy of marking plate.
N/A
Annex S
(informativ
e)
e)
Added annex S:
Illustration relative to safety explanation in
normative Chinese、Tibetan、Mongolian、Zhuang
Language and Uighur.
Illustration relative to safety explanation in
normative Chinese、Tibetan、Mongolian、Zhuang
Language and Uighur.
Language of relative to safety:
Chinese.
Chinese.
N/A
Page 6 of 6
Report No.: 232173
ATTACHMENT 6
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
Annex J.6 After the first paragraph, added a paragraph:
For apparatus intended to be operated at altitudes
between 2 000m and 5 000m, the Minimum
CLEARANCES in table J.2 shall multiply with
multiplication factor 1.48 in table A.2 of GB/T
16935.1. For apparatus intended to be operated at
altitude more than 5 000m, Minimum
CLEARANCES shall multiply with corresponding
multiplication factor in table A.2 of GB/T 16935.1.
between 2 000m and 5 000m, the Minimum
CLEARANCES in table J.2 shall multiply with
multiplication factor 1.48 in table A.2 of GB/T
16935.1. For apparatus intended to be operated at
altitude more than 5 000m, Minimum
CLEARANCES shall multiply with corresponding
multiplication factor in table A.2 of GB/T 16935.1.
The apparatus intended to
be operated at altitudes up to
2 000m.
be operated at altitudes up to
2 000m.
N/A
Delete note 3 of table J.6.
Noted
Annex R
(normativ
e)
(normativ
e)
Added annex R:
Instructions for the new safety warning labels.
R.1 Altitude warning label
Instructions for the new safety warning labels.
R.1 Altitude warning label
Meaning of the label: Evaluation for apparatus only
based on altitude not exceeding 2000m, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used at altitude above
2000m .
R.2 Climate warning label
based on altitude not exceeding 2000m, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used at altitude above
2000m .
R.2 Climate warning label
Meaning of the label: Evaluation for apparatus only
based on temperate climate condition, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used in tropical climate
region.
based on temperate climate condition, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used in tropical climate
region.
The apparatus intended to
be operated at altitudes up to
2 000m, and a
be operated at altitudes up to
2 000m, and a
ppropriate
wording provided as follows,
See copy of marking plate
The apparatus intended to
be used in not tropical climate
regions, and a
be used in not tropical climate
regions, and a
ppropriate
wording provided as follows
See copy of marking plate.
N/A
Annex S
(informativ
e)
e)
Added annex S:
Illustration relative to safety explanation in
normative Chinese、Tibetan、Mongolian、Zhuang
Language and Uighur.
Illustration relative to safety explanation in
normative Chinese、Tibetan、Mongolian、Zhuang
Language and Uighur.
Language of relative to safety:
Chinese.
Chinese.
N/A
Page 6 of 6
Report No.: 232173
ATTACHMENT 6
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
Annex J.6 After the first paragraph, added a paragraph:
For apparatus intended to be operated at altitudes
between 2 000m and 5 000m, the Minimum
CLEARANCES in table J.2 shall multiply with
multiplication factor 1.48 in table A.2 of GB/T
16935.1. For apparatus intended to be operated at
altitude more than 5 000m, Minimum
CLEARANCES shall multiply with corresponding
multiplication factor in table A.2 of GB/T 16935.1.
between 2 000m and 5 000m, the Minimum
CLEARANCES in table J.2 shall multiply with
multiplication factor 1.48 in table A.2 of GB/T
16935.1. For apparatus intended to be operated at
altitude more than 5 000m, Minimum
CLEARANCES shall multiply with corresponding
multiplication factor in table A.2 of GB/T 16935.1.
The apparatus intended to
be operated at altitudes up to
2 000m.
be operated at altitudes up to
2 000m.
N/A
Delete note 3 of table J.6.
Noted
Annex R
(normativ
e)
(normativ
e)
Added annex R:
Instructions for the new safety warning labels.
R.1 Altitude warning label
Instructions for the new safety warning labels.
R.1 Altitude warning label
Meaning of the label: Evaluation for apparatus only
based on altitude not exceeding 2000m, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used at altitude above
2000m .
R.2 Climate warning label
based on altitude not exceeding 2000m, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used at altitude above
2000m .
R.2 Climate warning label
Meaning of the label: Evaluation for apparatus only
based on temperate climate condition, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used in tropical climate
region.
based on temperate climate condition, therefor it’s
the only operating condition applied for the
equipment .There may be some potential safety
hazard if the equipment is used in tropical climate
region.
The apparatus intended to
be operated at altitudes up to
2 000m, and a
be operated at altitudes up to
2 000m, and a
ppropriate
wording provided as follows,
See copy of marking plate
The apparatus intended to
be used in not tropical climate
regions, and a
be used in not tropical climate
regions, and a
ppropriate
wording provided as follows
See copy of marking plate.
N/A
Annex S
(informativ
e)
e)
Added annex S:
Illustration relative to safety explanation in
normative Chinese、Tibetan、Mongolian、Zhuang
Language and Uighur.
Illustration relative to safety explanation in
normative Chinese、Tibetan、Mongolian、Zhuang
Language and Uighur.
Language of relative to safety:
Chinese.
Chinese.
N/A
