Sony KD-30XS955 Service Manual ▷ View online
30
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
DGC
DY
Rev. 1
7/12/04
7/12/04
CRT BRACKET
!
Wrap x5 LOOP (for 30W)
Wrap x2 LOOP (for 34W)
NO SLACK ON WIRE!
Wrap x2 LOOP (for 34W)
NO SLACK ON WIRE!
!
Caution:
Make sure
hook is
secure on CRT
pierce!
Make sure
hook is
secure on CRT
pierce!
Caution:
Make sure
hook is
secure on CRT
pierce!
Make sure
hook is
secure on CRT
pierce!
!
!
Wrap x5 LOOP (for 30W)
Wrap x2 LOOP (for 34W)
NO SLACK ON WIRE!
Wrap x2 LOOP (for 34W)
NO SLACK ON WIRE!
Caution:
Make sure Cable
Tie is TIGHTENED
once CRT is in
Vertical postion.
Make sure Cable
Tie is TIGHTENED
once CRT is in
Vertical postion.
Caution:
Make sure Cable
Tie is TIGHTENED
once CRT is in
Vertical postion.
Make sure Cable
Tie is TIGHTENED
once CRT is in
Vertical postion.
2-022-978-01
Wire Clip (2 Places)
1-900-803-55
DGC Restraint Cable
1-910-000-13
DGC Restraint Cable
DGC ASSEMBLY CAUTION POINT (KD-30XS955/34SX955 ONLY)
DY
Rotation
COIL
COIL
Rev. 1
7/12/04
7/12/04
CRT BRKT
NOTE: Leads are
dressed inside
Rotation Coil.
dressed inside
Rotation Coil.
NOTE2: There are
2 Leads (TOTAL 4
Wires) to connect
to CX-Board
2 Leads (TOTAL 4
Wires) to connect
to CX-Board
ECG - P/N
1-900-808-30 - 30 WCRT
1-900-808-31 - 34W CRT
1-900-808-30 - 30 WCRT
1-900-808-31 - 34W CRT
SPRING (2 places)
Integral part of
the Ground wire
the Ground wire
2-022-978-01
Wire Clip (2 Places)
EGC WIRE DRESSING (KD-30XS955/34SX955 ONLY)
31
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
g
QBOX WIRE DRESSING (ALL EXCEPT KV-34XBR960)
11P Conn. Assy.
(p/n: 1-900-806-86)
is dressed with 14P
Conn. Assy.
(p/n: 1-900-808-41)
with 9mm purselock
(p/n: 3-703-982-02)
NOTE direction of
wires in purselock.
(p/n: 1-900-806-86)
is dressed with 14P
Conn. Assy.
(p/n: 1-900-808-41)
with 9mm purselock
(p/n: 3-703-982-02)
NOTE direction of
wires in purselock.
CRITICAL POINT:
14P Conn. Assy. (P-shield to MZ-Bd, p/n: 1-900-808-41)
14P Conn. Assy. (P-shield to MZ-Bd, p/n: 1-900-808-41)
Note Direction of wires dressed in
MUST be dressed as far back in the chassis as possible.
11mm purselock (p/n: 3-703-983-02)
NOTE position of the ferrite core (adjacent to P-shield).
CHASSIS WIRE DRESSING DETAIL (ALL EXCEPT KV-34XBR960)
32
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
x3 11mm purselock
(NOTE positions of
purselocks on main
cable bundle.)
purselocks on main
cable bundle.)
CRITICAL POINT:
Main cable bundle MUST be dressed as LOW
as possible between cement resistor and heat sink.
Wires cannot touch heat sink (sharp edges) or the
cement resistor (very hot).
Main cable bundle MUST be dressed as LOW
as possible between cement resistor and heat sink.
Wires cannot touch heat sink (sharp edges) or the
cement resistor (very hot).
CHASSIS WIRE DRESSING DETAIL (ALL EXCEPT KV-34XBR960)
XS Models do NOT
have Sub-Tuner
Pin-Plug Cable
have Sub-Tuner
Pin-Plug Cable
XS Models do NOT
have iLINK (iEEE)
Cable.
have iLINK (iEEE)
Cable.
CHASSIS WIRE DRESSING DETAIL (ALL EXCEPT KV-34XBR960)
33
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
TAB on AZ-Bd is slightly bent at 45
Double ground wire is
TAB on QH-Bd is bent 45
away from memory stick
angle (towards front of set)
dressed in H-Bracket
connector.
clip.
Reason: If TAB is not bent over, wires may get
snagged on DGC and break tab off PWB when
inserting chassis into set.
snagged on DGC and break tab off PWB when
inserting chassis into set.
CHASSIS WIRE DRESSING DETAIL (ALL EXCEPT KV-34XBR960)
UZ-Bd to HBZ-Bd Conn. Assy. (with Red taping,
p/n: 1-900-806-83)
Dressed in purselock on MZ-Bd (p/n: 4-355-912-xx)
4P WY-Bd to DL-Bd Conn. Assy. (with Red Housing,
p/n 1-900-808-02)
p/n: 1-900-806-83)
Dressed in purselock on MZ-Bd (p/n: 4-355-912-xx)
4P WY-Bd to DL-Bd Conn. Assy. (with Red Housing,
p/n 1-900-808-02)
Both 1-900-806-83 and 1-900-808-02 dressed in 9mm
purselock (p/n: 3-703-982-02)
purselock (p/n: 3-703-982-02)
Both 1-900-806-83 and 1-900-808-02 dressed in
H-Bracket Clip
NOTE: Directions of cables INSIDE clip.
(Black cable dressed in H-Bracket clip is USB cable
(QBOX to QH-Bd, p/n: 1-829-191-11)
H-Bracket Clip
NOTE: Directions of cables INSIDE clip.
(Black cable dressed in H-Bracket clip is USB cable
(QBOX to QH-Bd, p/n: 1-829-191-11)
CHASSIS WIRE DRESSING DETAIL (ALL EXCEPT KV-34XBR960)
Click on the first or last page to see other KD-30XS955 service manuals if exist.