Sony KD-30XS955 Service Manual ▷ View online
26
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
WIRE DRESSING - TOP OF QBOX (KD-34XBR960 ONLY)
1-900-805-24 ground
wire attached here
on Antenna Switch
wire attached here
on Antenna Switch
Note direction of
purselocks and
postion of ferrite cores
purselocks and
postion of ferrite cores
Ferrite Core: NOTE LOCATION- IMPORTANT for EMI
Ferrite Core: NOTE LOCATION- IMPORTANT for EMI
p/n: 1-500-484-21
p/n: 1-543-793-11
TDK ZCAT-2017-0930-M
TDK ZCAT-1325-0530A
1-900-805-24 ground wire is dressed in wire clamp. p/n: 4-857-472-01
Wire is dressed BEFORE securing position of Antenna Switch.
Wire is dressed BEFORE securing position of Antenna Switch.
WIRE DRESSING - ANT SW GROUND WIRE (KD-34XBR960 ONLY)
27
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
WIRE DRESSING - F-PIN DRESSING (KD-34XBR960 ONLY)
Note position (rotation of right-angle connector) of the cable/ferrite.
Do NOT dress the ferrite core so it can touch the Heat sink on the POD connector (not installed in this photo)
Do NOT dress the ferrite core so it can touch the Heat sink on the POD connector (not installed in this photo)
NOTE " Z " Routing of USB Cable routing (important for EMI).
Position of Ferrite Core is Important for EMI.
Position of Ferrite Core is Important for EMI.
WIRE DRESSING -FRONT OF Q BOX (KD-34XBR960 ONLY)
28
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
WIRE DRESSING - 11MM P BOARD CONNECTION (KD-34XBR960 ONLY)
29
KD-30XS955/34XBR960/34XS955/36XS955
KD-30XS955/34XBR960/34XS955/36XS955
DCG LEAD WIRE DRESSING (ALL EXCEPT KD-34XBR960)
DY
Rev. 1
5/10/04
5/10/04
Cable Tie
4-041-041-02
4-041-041-02
STEP1:
Make a loop in leads
and route loop BEHIND
The DGC Coil.
Make a loop in leads
and route loop BEHIND
The DGC Coil.
STEP 2:
Thread both connector
housings through the
loop in lead wires.
Thread both connector
housings through the
loop in lead wires.
STEP 3:
Plug in connector
housings into the
[AZ] Board using the
loop to take up slack.
Plug in connector
housings into the
[AZ] Board using the
loop to take up slack.
Click on the first or last page to see other KD-30XS955 service manuals if exist.