DOWNLOAD Sony DCR-TRV250 (serv.man3) Service Manual ↓ Size: 8.16 MB | Pages: 127 in PDF or view online for FREE

Use the Sony XB-3D halogen lamp (optional). The supplied halogen lamp is not
commercially available. Purchase the Sony XB-3D halogen lamp.
Remove the power source before replacing the bulb.

(1) Remove the built-in light unit while pushing the hole under the built-in light

unit using a wire.

(2) Turn the bulb housing counterclockwise and detach from the built-in light

unit.

(3) Replace the bulb using a dry cloth.
(4) Attach the bulb housing by turning it clockwise, then replace the built-in light

unit.

•When replacing the bulb, use only the Sony XB-3D halogen lamp (optional) to reduce

the risk of fire.

•To prevent possible burn hazard, disconnect the power source before replacing and

do not touch the bulb until the bulb becomes cool enough to handle (for about 30
minutes or more).

Note
To prevent the bulb from being smudged with finger prints, handle it with a dry cloth,
etc. If the bulb is smudged, wipe it thoroughly.

You can insert a scene in the middle of a recorded tape by setting the start and end
points. The previously recorded frames between these start and end points will be
erased.
Use the Remote Commander for this operation.

(1) In the standby mode, keep pressing EDITSEARCH, and release the button at

the insert end point [b].

(2) Press ZERO SET MEMORY on the Remote Commander.

The ZERO SET MEMORY indicator flashes and the counter resets to zero.

(3) Keep pressing the – 7 side of EDITSEARCH and release the button at the

insert start point [a].

(4) Press START/STOP to start recording.

The scene is inserted. Recording stops automatically near the counter zero
point. Your camcorder returns to the standby mode.
The zero set memory function is canceled.

Notes
•The zero set memory function does not work with tapes recorded in the Hi8 

/

standard 8 mm   system.

•The picture and the sound may be distorted at the end of the inserted section when it

is played back.

If a tape has a blank portion between recorded portions
The zero set memory function may not work correctly.

During playback, you can process a scene using the following picture effects:
NEG.ART, SEPIA, B&W and SOLARIZE.

(1) In the playback or playback pause mode, press MENU to display the menu

settings.

(2) Turn the SEL/PUSH EXEC dial to select P EFFECT in 

, then press the dial

(p. 211).

(3) Turn the SEL/PUSH EXEC dial to select the desired picture effect mode, then

press the dial.
For details of each picture effect, see page 64.

Set P EFFECT to OFF in the menu settings.

MANUAL  SET
  P  EFFECT
  D  EFFECT
    RETURN

[MENU] : END

OFF
NEG. ART
SEPIA
B&W
SOLARIZE

Notes
•You cannot record images on a tape on your camcorder while you are processing the

image using Picture effect. However, you can record images as follows:
– on a “Memory Stick” as a still image 

 

– on a VCR using your camcorder as a player

•Picture effect does not work with tapes recorded in the Hi8 

/standard 8 mm 

system.

•You cannot process externally input scenes using Picture effect.

Pictures processed by Picture effect
Pictures processed by Picture effect are not output through the   DV jack.

When you set the POWER switch to OFF (CHG) or stop playing back
Picture effect is automatically canceled.