Sony SAL24105 Service Manual ▷ View online
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP31
1.
Attach the zoom ring, aligning its projection (near “105”) with the cut portion (cut portion of index block) of fixed holding tube
block.
2.
Rotate counterclockwise the zoom ring a little and tighten the zoom operating pin, aligning the “U” shaped groove with the screw
hole of focus cam tube.
24
Cut Portion
Projection
105
Zoom Ring
Screw Hole of Focus
Cam Tube
Cam Tube
U Shaped
Groove
Zoom Ring
Fixed Holding Tube Block
Index Block
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP32
Grease (G-85):
J-6082-626-A
Anti-diffusion agent (A-20): J-6082-611-A
1.
Apply the anti-diffusion agent (A-20) to the indicated portion shown in the figure.
2.
Apply the grease (G-85) to the indicated portion (side of lead groove of indicated inner portion) of zoom ring.
HELP33
Grease (G-85): J-6082-626-A
Apply the grease (G-85) to the indicated portion of fixed holding tube block.
Note:
Do not apply the grease to the 1/2 area of cam groove near the main flexible PC board block and the slider groove of zoom ring at
the lower side of main flexible PC board block.
Apply the grease (G-85)
Apply the anti-diffusion agent
(A-20)
(A-20)
Zoom Ring
Pin (Zoom Operating Pin)
Fixed Holding Tube Block
Apply the grease (G-85)
Apply the grease (G-85)
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP34
1.
Attach the focus cam tube, aligning its projection (the projection furthest to the linear guide key) with the cut portion (cut portion
nearest to the gear (C, D) block insertion area) of fixed holding tube block.
2.
After installation, rotate the focus cam tube block in the arrow direction.
Cut Portion
Focus Cam Tube Block
Linear Guide Key
Focus Cam Tube Block
Projection
Fixed Holding Tube Block
Fixed Holding Tube Block
Gear (C, D) Block Insertion Block
HELP
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
HELP35
Affix the light shield sheet A with the polyester tape (black) 10mm in the length of 25mm with two sheets overlaid, starting with the
position opposite to the straight groove of focus cam tube block.
Note:
At this moment, be careful for the polyester tape (black) 10m not to cover by the cam tube.
HELP36
1.
Set the focus cam tube block to “Tele end” by rotating the cam tube in the arrow direction.
2.
Insert the focus operating lever installing block in the focus cam tube block, aligning.
2nd Lens Block
Focus Operating Lever Installing Block
Straight Groove
Focus Cam Tube Block
Cam Groove
Polyester Tape
(20x25mm)
(20x25mm)
Light Shield Sheet A
Reference to Affixing
Focus Cam Tube Block
Click on the first or last page to see other SAL24105 service manuals if exist.