Sony DSC-S5000 Service Manual ▷ View online
DSC-S5000
3-1
1. After the part replacement, make sure to check whether there is no focus blurring in the centre and four areas around the
centre of the image with the specified method described as below as 3-6. Various Checks.
2. If the symptom cannot be improved with this repair method, take the repair of LENS BLOCK ASSY replacement as usual.
1. Disconnect the soldered connection.
2. Remove the two screws.
3. Remove the four screws.
3-1. Disassembling
Note
Rear retainer
Rear lens spring
2ND FOCUS GEAR
ZOOM LONG GEAR
Focusing
shaft assy
shaft assy
Rear lens
4. Remove the rear retainer with careful attention so as not to let the rear lens spring fly away.
Remove the rear lens spring.
5. Remove the ZOOM LONG GEAR and the 2ND FOCUS GEAR.
6. Remove the following two items together.
(Rear lens, Focusing shaft assy)
3. DISASSEMBLY/ASSEMBLY
Ver. 1.3 2013.07
DSC-S5000
3-2
Hooked part for
Zoom drive
Zoom drive
Gear driver
(J6082750A)
(J6082750A)
Passed
7. Remove the hooked part for Zoom drive.
Then attach a long gear such as Gear driver (J6082750A) or a removed ZOOM LONG GEAR.
8. Turn the long gear counter-clockwise to set the block in the TELE end state.
9. Pass the FPC through the hole.
The inner-block_1
FIXED BARREL
10. Turn the barrel to the point of overtaking a little the retracted position.
11. Remove the inner-block_1 from the FIXED BARREL.
DSC-S5000
3-3
The inner-block_2
Remained DRIVE BARREL
& LINEAR CAM BARREL
& LINEAR CAM BARREL
The inner-block_1
DRIVE BARREL
LINEAR CAM BARREL
Remained DRIVE BARREL
& LINEAR CAM BARREL
& LINEAR CAM BARREL
12.
Disjoin the inner-block_1 with removing the inner-block_2 linearly in the arrow direction while holding the united
DRIVE BARREL & LINEAR CAM BARREL.
DRIVE BARREL & LINEAR CAM BARREL.
< Reference >
At this point, the remaining united DRIVE BARREL & LINEAR CAM BARREL are able to be separated
and replaced.
and replaced.
The inner-block_2
Linear guide ring
The inner-block_3
Before turning three pins
After turning
13. Disjoin the inner-block_2 with removing the linear guide ring linearly in the arrow direction while holding the inner-
block_3.
14. Turn the three pins in the arrow direction while holding the outmost barrel. (approx. 120 degrees)
DSC-S5000
3-4
The inner-block_3
2ND OUTER BARREL
The front barrel part
The inner-block_4
15. Disjoin the inner-block_3 with removing the following 3 units linearly in the arrow direction.
The inner-block_4
CAM BARREL
Shutter assy
16. Disjoin the inner-block_4 with removing the shutter assy linearly in the arrow direction.
Click on the first or last page to see other DSC-S5000 service manuals if exist.