DOWNLOAD Sony DSC-S5000 Service Manual ↓ Size: 3.62 MB | Pages: 27 in PDF or view online for FREE

Model
DSC-S5000
Pages
27
Size
3.62 MB
Type
PDF
Document
Service Manual
Brand
Device
Digital Camera
File
dsc-s5000.pdf
Date
PREV: Sony DSC-WX70 (serv.man3) Service Manual

Sony DSC-S5000 Service Manual ▷ View online

DSC-S5000
3-5
 
1. Disconnect the soldered connection.
2. Remove the four screws.  
3. Remove the four screws.   
3-2.  Replacing MOTOR UNIT
Rear retainer 
 
Rear lens spring 
2ND FOCUS GEAR
 
PI part 
4. Remove the rear retainer with careful attention so as not to let the rear lens spring fly away.
5. Remove the 2ND FOCUS GEAR.
6. Remove the PI part with a tool such as flat-blade screwdriver.  
DSC-S5000
3-6
Part for Zoom drive 
FPC affixed with 
Double-faced-tape 
FPC affixed with
Double-faced-
tape 
PI part 
7. Remove the part for Zoom drive. Remove the part of the FPC affixed with Double-faced-tape.  
8. Remove the part of the FPC affixed with Double-faced-tape.  
9. Remove the PI part with a tool such as flat-blade screwdriver. 
 
Part of Focus motor 
10. Remove the part of Focus motor.
11. MOTOR UNIT can be removed.
12. After the MOTOR UNIT has been replaced with a new one, return the process from 11. to 1. according to the process 
flow.   
DSC-S5000
3-7
To Tele, apply a positive supply voltage (+) of 
DC2.5 V here.
Outside 
Inside 
1. Set the lens to Tele position.
2. Heat the COSMETIC RING up with a heater such as hair dryer.  
Pour a solvent such as ethyl alcohol.  
Pick the COSMETIC RING with a thin tool such as cutter knife.   
3-3. Replacing BARRIER ASSY  
Outside 
Inside 
3. Unlock the four hooks with a thin tool.
4. BARRIER ASSY can be removed.  
 
 
 
 
 
 
DSC-S5000
3-8
Outside 
Inside
 
Lever 
Space for the lever of Lens barrier 
 
5. After the BARRIER ASSY has been replaced with a new one, return the process from 4. to 1. according 
to the process flow.
Note: Align the lever with the dedicated space as shown in the figure
3-4. Assembly
Assembly-1: Installation Cautions of the Mylar ST Block.
Switch
Mylar ST Block
Strobe Board
When affixing the mylar ST block to the strobe board, 
be careful for mylar ST block not to overlap the switch.
Assembly-2: Installation Cautions of the Main-Frame Sheet.
Attach the Main-Frame Sheet as shown below.
Microphone
Harness
Main-Frame
Sheet
Main Board
Assembly-3: Installation Cautions of the Speaker (1.3cm).
Route the Speaker Harness as shown below.
Speaker Harness
Speaker Harness
Main Board
Page of 27
Display

Click on the first or last page to see other DSC-S5000 service manuals if exist.

RANDOM: