Sony DSC-QX10 Service Manual ▷ View online
DSC-QX10
4-11
A
A
Flexible Board
Flexible Board
Main Body
Main Body
Rotary Cam Tube
Rotary Tube
Stationary Tube Assy
Gear A
Gear A
Gear B
Gear Worm
Wheel
Wheel
Rear Mirror
Plate
Plate
8. Detach the Rear Mirror Plate and remove the Gear Worm Wheel, Gear A, and Gear B.
10. Turn portion A in the arrow direction to TELE end and remove the Flexible Board from the hole in the Stationary Tube Assy.
9. Turn the Gear in the arrow direction to extend the Mirror Plate slightly.
11. Turn portion A in the arrow direction to WIDE end and detach the Main Body from the Stationary Tube Assy.
12. Remove the Main Body in the arrow direction.
13.
13.
Remove the Rotary Cam Tube from the Rotary Tube in the arrow direction.
DSC-QX10
4-12
Lens Block
1 Frame Assy
Cam Tube A
3 Group Assy
Tweezers
Claw
Claw
14. Turn the 3 Group Assy approx. 20° in the arrow direction.
15. Disengage the three claws with tweezers.
15. Disengage the three claws with tweezers.
16. Remove the Lens Block.
17. Remove the 1 Frame Assy from the Cam Tube A.
17. Remove the 1 Frame Assy from the Cam Tube A.
DSC-QX10
4-13
Cam Tube B
Cam Tube B
2 Group Frame
3 Group Assy
Straight Tube Block
Straight Tube
Straight Tube
18. Fully turn the Cam Tube B in the arrow direction.
19. Remove the 2 Group Frame.
20. Remove the Straight Tube Block.
20. Remove the Straight Tube Block.
21. Turn the Straight Tube in the arrow direction to detach it from the Cam Tube B.
DSC-QX10
4-14
White Part
Thinnest Groove
Cam Tube B
Cam Tube B
Lever
Cutout
Straight Tube
Straight Tube
3 Group Assy
Straight Tube Block
2 Group Frame
2 Group Frame
Shaft of 3 Group Assy
Top side view
Installation
1. Align the Lever with the cutout as shown in the figure, and then install the Straight Tube to the Cam Tube B.
Note: Be sure to set the Straight Tube at the correct insertion position.
2. Turn the Straight Tube in the arrow direction to the maximum.
Note: Be sure to set the Straight Tube at the correct insertion position.
2. Turn the Straight Tube in the arrow direction to the maximum.
3. Install the Straight Tube Block aligning the thinnest groove with the white part as shown in the figure, and then turn
the Cam Tube B in the arrow direction to the maximum.
the Cam Tube B in the arrow direction to the maximum.
4. Install the 2 Group Frame at a position where the Shaft of 3 Group Assy is visible through the cutout of the 2 Group Frame.
Click on the first or last page to see other DSC-QX10 service manuals if exist.