Sony XR-M510 Service Manual ▷ View online
13
XR-M510
HEAT SINK
4
three screws
(PTT2.6
(PTT2.6
×
8)
4
two screws
(PTT2.6
(PTT2.6
×
8)
2
connector
(CN100)
(CN100)
3
cord (with connector) (ANT)
6
heat sink
1
Remove solder of
cord (with connector) (ANT).
cord (with connector) (ANT).
5
two screws
(PTT2.6
(PTT2.6
×
12)
14
XR-M510
SECTION 4
ASSEMBLY
Note:
Follow the assembly procedure in the numerical order given.
4-1.
FRONT PANEL MACHINERY
MOTOR BLOCK ASSY
CAM (R) ASSY
8
two screws
(PTT2.6
(PTT2.6
×
6)
9
screw (BTT)
1
cam (L)
6
washer (M)
5
gear (C)
6
washer (M)
6
washer (M)
4
gear (B)
3
gear (A)
7
bracket (motor) assy
Set bracket (motor) assy
to be at the position in the
figure.
to be at the position in the
figure.
switch
concave portion
hole
2
stop ring 1.5
Note: When installing cam (L), adjust the hole and concave portion.
1
cam (R)
concave portion
hole
2
stop ring 1.5
Note: When installing cam (R), adjust the hole and concave portion.
15
XR-M510
MOTOR BLOCK ASSY, CAM (R) ASSY
4
screw
(PTT2.6
(PTT2.6
×
6)
7
screw
(PTT2.6
(PTT2.6
×
6)
3
motor block assy
4
screw
(PTT2.6
(PTT2.6
×
6)
6
cam (R) assy
5
connector
(CN602)
(CN602)
5
connector
(CN501)
(CN501)
black wiring
yellow wiring
1
Supply the power to the motor.
Voltage
: 9V
Yellow wiring : MOTOR –
Black wiring : MOTOR +
Black wiring : MOTOR +
2
Motor stops at full open position.
full open position
–
+
7
screw
(PTT2.6
(PTT2.6
×
6)
16
XR-M510
4-2.
MECHANISM DECK
HOUSING
ARM (SUCTION)
A
part
C
part
B
part
D
part
8
Hold the hanger by
bending the claw.
bending the claw.
6
Fit projection on
D
part.
4
Fit claw on
B
part.
3
Put the housing
under
under
A
part.
5
Fit projection on
C
part.
1
Install the catch to the hanger.
2
Install the hanger onto
two claws of the housing.
two claws of the housing.
7
Holder the hanger by bending the claw.
hanger
housing
2
Move the arm (suction) in the arrow
direction and fit on projection.
direction and fit on projection.
1
Fit the arm (suction) on the shaft.
projection
Click on the first or last page to see other XR-M510 service manuals if exist.