Sharp XG-C40XE (serv.man15) Service Manual ▷ View online
13
XG-C40XU/XE
SHARP
Lamp unit
Lamp cover
1-2
Intake cover
1-1
1-3
1-3
REMOVING OF MAJOR PARTS
1. Removing the Intake cover and lamp unit
1-1. Detach the Intake cover.
1-2. Loosen the lamp cover screw and draw out the lamp cover in the direction of arrow (toward yourself).
1-3. Remove the two lamp unit lock screws. Detach the lamp unit.
1-2. Loosen the lamp cover screw and draw out the lamp cover in the direction of arrow (toward yourself).
1-3. Remove the two lamp unit lock screws. Detach the lamp unit.
Note:
When replacing the lamp, make sure
that there is a clearance of over
8mm between the terminal and the
lamp snap-on spring (and other
metallic parts).
that there is a clearance of over
8mm between the terminal and the
lamp snap-on spring (and other
metallic parts).
14
XG-C40XU/XE
SHARP
Press both sides of the bottom
cabinet in the directions of
arrow to undo the hooks. Lift
and detach the top cabinet.
cabinet in the directions of
arrow to undo the hooks. Lift
and detach the top cabinet.
Hook
2-1
2-2
2-3
(KY)
Top cabinet
Rear cabinet
2-4
2. Removing the top and rear cabinets
2-1. Remove the four rear cabinet lock screws.
2-2. Remove the four terminal board lock screws off the rear cabinet. Unhook and detach the rear cabinet from
2-2. Remove the four terminal board lock screws off the rear cabinet. Unhook and detach the rear cabinet from
below.
2-3. Remove the four top cabinet lock screws from below.
2-4. Slowly lift the top cabinet and disconnect the operation key unit connector (KY). Then take away the top
cabinet.
15
XG-C40XU/XE
PC Terminal Unit
Video Unit
Signal Unit
PC I/F Unit
Spacer (stud bolt)
Output Unit
S-out/REG Unit Angle
S-out/REG Unit
3-1
3-1
3-2
3-2
3-3
3-3
3-3
3-4
(FP)
(FS)
(Q)
(FN)
(TP)
(EB)
(EB)
(SO)
(SP)
(EA)
(SO)
(F)
(L)
3. Removing the PWB units
3-1. Disconnect the connectors from the output unit.
3-2. Remove the four PC I/F unit lock screws.
3-2. Remove the four PC I/F unit lock screws.
Remove the two screws and the earth shield, and take out the PC I/F unit.
3-3. Remove the spacer (stud bolt) and the three screws off the output unit. Lift the output unit, together with the
signal unit, off the position.
3-4. Remove the S-out/REG unit angle lock screw and take out the S-out/REG unit.
16
XG-C40XU/XE
4-1
Optical Mechanism Unit
Duct Fan Unit
4-2
4. Removing the optical mechanism unit
4-1. Remove the six optical mechanism unit lock screws. Lift the unit off the position.
4-2. Remove the two lamp socket holder lock screws and take out the holder.
4-2. Remove the two lamp socket holder lock screws and take out the holder.
Click on the first or last page to see other XG-C40XE (serv.man15) service manuals if exist.