Sharp MX-ST10 Service Manual ▷ View online
MX-ST10 MAINTENANCE 5 - 2
3)
Removed the shift unit. (Circled section)
Remove two screws. While lowering the front side of the shift
unit, remove the unit. (The guide pin is in the rear side.)
Remove two screws. While lowering the front side of the shift
unit, remove the unit. (The guide pin is in the rear side.)
4)
Remove the cover. (Indicated with a red line.)
5)
Remove the plate mounting screw and the beam sensor
mounting screw in the front side. (Circled sections)
mounting screw in the front side. (Circled sections)
Guide pin
Shift unit
MX-ST10 MAINTENANCE 5 - 3
6)
Remove the plate mounting screw and the beam sensor
mounting screw in the rear side. (Circled sections)
mounting screw in the rear side. (Circled sections)
7)
Disconnect the connector (arrow section) of the stack position
sensor, and remove the plate.
sensor, and remove the plate.
8)
Remove the E-ring and the bearing in front of the paddle shaft.
(Circled section)
When attaching the bearing, attach it so that the flange of the
bearing comes in the inside of the frame.
(Circled section)
When attaching the bearing, attach it so that the flange of the
bearing comes in the inside of the frame.
9)
Remove the motor A'ssy in the rear side of the shift unit.
(Circled sections)
(Circled sections)
MX-ST10 MAINTENANCE 5 - 4
10) Remove the E-ring and the bearing in the rear side of the pad-
dle shaft. (Circled section)
When attaching the bearing, attach it so that the flange of the
bearing comes in the inside of the frame.
When attaching the bearing, attach it so that the flange of the
bearing comes in the inside of the frame.
11) Remove the E-ring , the pulley, and the bearing in the rear side
of the paddle shaft. (Circled section)
12) Replace the paddle shaft.
13) Assemble in the sequence of step 12)-->11)-->10)...1).
13) Assemble in the sequence of step 12)-->11)-->10)...1).
Be careful of the direction of the bearings step 10) and 8).
Paddle shaft
MX-ST10 DISASSEMBLY AND ASSEMBLY 6 - 1
[6] DISASSEMBLY AND ASSEMBLY
1. Shift unit disassembly procedures
1)
Remove the screws, and remove the cover. (Circled sections)
2)
Remove the harness and remove the harness clamp.
(Arrow sections)
(Arrow sections)
Click on the first or last page to see other MX-ST10 service manuals if exist.