DOWNLOAD Sharp MX-M200D / MX-M200DK Service Manual ↓ Size: 715.75 KB | Pages: 32 in PDF or view online for FREE

 

 

 

17 

Firmware Upgrade Procedure 

 

General 

In preparation for downloading new firmware to a MX-M160D or 200D it is necessary 
to install a USB driver on the PC to allow the transfer of the firmware file from PC to 
MFP.  Once the driver has been installed it will then be possible to connect to the 
MFP using the Integrated Maintenance (Download) Programme. 

  The USB driver does not need to be installed each time the Maintenance 

Programme is required. 

USB Driver installation procedure 

The following procedure describes the installation of the USB driver onto a PC 
running the Microsoft Windows XP operating system. 

1.  Put the MFP into ‘Download’ Mode by entering Simulation 49-01 (d should be 

displayed in the control panel LCD). 

2.  Connect an ‘A’ to ‘B’ type usb cable between the PC and the MFP USB 1.1 

port as shown below.

 

 

 

 

 

 

18 

3. Start Windows, the Found new hardware wizard will identify “Download” as a 

new device. 

4.  If the wizard requests to connect to Windows Update, select No, not this time.  

Click Next to continue. 

5. Select Install from a list or a specific location (Advanced) and click Next. 
6. Ensure the Search for the best drivers in these locations button is selected 

and that the Include this location in the search is the only checkbox ticked. 

7. Click Browse and select the required folder that contains the correct USB 

driver for the operating system being used. 

8. Click Next and then Finish to complete the driver installation.  If the driver is 

not digitally signed, click Continue anyway. 

9.  To check the installation of the USB driver was completed successfully, open 

 and then System:- 

Click the Hardware and then Device Manager Tabs and expand Universal 
Serial Bus controllers

.  Confirm that the Maintenance Tool Generic USB driver 

is listed.  The USB device driver installation is now complete; it will now be 
possible to run the Maintenance Programme. 

 

 

 

19 

Firmware Upgrade Procedure 

 

Requirements: 

•  PC with a USB port running a compatible Windows OS. 
•  USB ‘A’ to ‘B’ type cable. 
•  ‘USB Device’ driver pre installed (See page17). 
• Integrated 

Maintenance 

tool and firmware to be uploaded. 

Procedure: 

1.  Put the MFP into download mode (Simulation 49-01). 
2.  Connect the USB cable between the PC and the MFP USB 1.1 port. 
3.  Launch the Integrated Maintenance tool (Version 04.20 or higher) and select 

the MX-M160/200 series and click on Select. 

          

 

 

 

 

 

 

 

20 

Firmware Upgrade Procedure 

 

4. Expand the Simulation Command List and double click Download DWL Data 

from within the Special folder. 

 

 

5.  Browse to the location of the new firmware file (*.dwl) and click open to start 

the firmware download.