Sharp MX-6500N / MX-7500N (serv.man10) Service Manual ▷ View online
MX-7500N MX-RB17 (CONNECTION MODULE) 10 – 2
4) Remove the step screws in the back on top of the 2nd tray on
both right and left sides.
5) Pull the slide rails out.
6) Place this unit on the rails.
7) Place the screw holes for this unit and the slide rails to the
same location and tighten them toge ther with 2 types of
screws.
(Right side: No.4 x2; left side: No.5 x2)
Stick the label (Packed items No.6) to the lower paper cassette
as shown in the picture below.
8) Close the 2nd tray and fix the front door.
9) Remove the cover fixing scre w in th e lower right side of the
9) Remove the cover fixing scre w in th e lower right side of the
first-series LCT, and attach the height adjustment mounting
plates (F/R) with the screws (Packed items No.5 x2).
Step screw
Step screw
MX-7500N MX-MF11 (MULTI BYPASS TRAY) 11 – 1
MX-7500N
Service Manual
[11] MX-MF11 (MULTI BYPASS TRAY)
1. Unpacking
A. Packed items check
2. Installation
NOTE: Before installation, be sure to turn both the operation and
main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.
A. Removal of the covers
NOTE: When removing the cabinet, insert a screwdriver (-) into the
circled sections in the figure below and remove.
1) Remove the multi bypass tray paper transportation cover.
2) Remove the multi bypass tray covers.
B. Installation of the multi bypass tray for LCT
1) Fasten the connection pins.
No.
Name
Quantity
1
Tab sheet restraint plate
1
2
Rear edge restraint plate
1
3
Bracket
1
4
Connection pin
2
5
Screws
3
MX-7500N MX-MF11 (MULTI BYPASS TRAY) 11 – 2
2) Fix the bracket with the screw.
3) Remove the multi bypass tray from the package.
NOTE: Use man power of two persons to lift the multi bypass
tray. (Refer to the figure below.)
C. Removal of the upper cabinet of the multi
bypass tray for LCT
1) Remove the screws and remove the upper cabinet.
MEMO: Remove the paper feed section with shifting it to the
direction of the arrow.
2) Mount the multi bypass tray on LCT and fix it with screws.
NOTE: Insert the connection pin to the positioning hole of the
multi bypass tray.
3) Connect the harnesses to LCT.
MEMO: Wire the harnesses through the cable clamp.
Screw hole
Screw hole
Connection pin
Connection pin
MX-7500N MX-MF11 (MULTI BYPASS TRAY) 11 – 3
4) Fix the upper cabinet with the screws.
MEMO: After fixing the cabinet, shift the paper feed section to
the direction of the arrow.
5) Open the front door of the LCT, and store the tab sheet
restraint plate to the place as shown in the figure below.
Click on the first or last page to see other MX-6500N / MX-7500N (serv.man10) service manuals if exist.