Sharp DX-C200P Service Manual ▷ View online
[5]Replacement and Adjustment
5-52
8. Disconnect the flat cable with the Ferrite core [C] and remove it (
x 1, hooks x 2).
9. Grounding screw [D] (
x 1)
10. FCU and Speaker bracket [E] (
x 5,
x 1,
x 2)
11. Controller board [F] (all
s,
x 6)
[5]Replacement and Adjustment
5-53
EGB (Engine Board)
Printer Models
1 Rear cover (
p. 5-5)
2. EGB [A] (
x 6, all
s)
3. EEPROM [B]
When installing the new EGB
[5]Replacement and Adjustment
5-54
4. Remove the EEPROM from the old EGB.
5. Install it on the new EGB with the mark [A] pointing to the right side of the board after
you replace the EGB.
6. Replace the EEPROM if the EEPROM on the old EGB is defective.
Keep the EEPROM away from objects that can cause static electricity. Static
electricity can damage EEPROM data.
Make sure that the EEPROM is correctly installed on the EGB.
DX-C200
7. Rear cover (
p. 5-5)
8. Controller box cover (
p. 5-49)
9. FCU and Speaker bracket (
p. 5-52)
[5]Replacement and Adjustment
5-55
10. EGB [A] (all
s,
x 6 )
11. EEPROM [B]
When installing the new EGB
12. Remove the EEPROM from the old EGB.
12. Remove the EEPROM from the old EGB.
Click on the first or last page to see other DX-C200P service manuals if exist.