DOWNLOAD Sharp AR-C200P (serv.man4) Service Manual ↓ Size: 6.27 MB | Pages: 127 in PDF or view online for FREE

AR-C200P   Rev.5 

17 /

 

(2)

Do not disassemble the printer so long as it operates properly.

(3)

Minimize the disassembly.  Do not detach parts other than those shown in the replacing procedure.

(4)

For maintenance, use designated tools.

(5)

Follow the order instructed to disassemble the printer.  Incorrect order may damage the parts.

(6)

Small parts such as screws and collars tend to get lost, so temporarily place and fix them in
their original positions.

(7)

When handling ICs and circuit boards such as microprocessors, ROMs and RAMs, do not use
gloves that likely to have static.

(8)

Do not place the printed circuit boards directly on the printer or the floor.

This section describes the procedure for replacing the parts, assemblies and units in the field.  The
replacing procedure is given for detachment.  To attach, use the reverse procedure.

2.1

Precautions in Replacing Parts

(1)

Before replacing the parts, be sure to remove the AC cable and the interface cable.

(a) To remove the AC cable, always use the following procedure.

i)

Flip the power switch of the printer off (to “O”).

ii)

Pull the AC inlet plug of the AC cable out of the AC receptable.

iii) Remove the AC cable and the interface cable from the printer.

(b) To connect the printer again, always use the following procedure.

i)

Connect the AC cable and the interface cable to the printer.

ii)

Insert the AC inlet plug into the AC receptacle.

iii) Flip the power switch of the printer on (to “I”).

Disconnect

Connect

AR-C200P   Rev.5 

18 /

 

[Maintenance Tools]

Table 2-1 lists tools necessary to replace the printed circuit boards and the units.

Table 2-1  Maintenance Tools

No.

No. 1-100 Philips
screwdriver

Q' ty

Place of use

Remarks

Service Tools

1

2

3

4

5

6

8

No. 2-200 Philips
screwdriver, Magnetized

No. 3-100 screwdriver

No. 5-200 screwdriver

Digital multimeter

Pliers

Handy cleaner

LED Head cleaner

High voltage probe

1

1

1

1

1

1

1

2~2.5 mm screws

3~5 mm screws

 

9

1

7

1

Transparency sheet
( thickness premeasured)
0ZZ42404301//

Stage height adjustment jig
0ZZ42423701//

-

Microdriver

2.0mm

Adjustment for Media
Thickness sensor

Adjustment for Media
Thickness sensor

Adjustment for Lever
adjust
(Media Thickness)

10

11

12

1

1

1

Label

AR-C200P   Rev.5 

19 /

 

2.2

Parts layout

Figure 2-1

A

A

B

B

A

A

B

AR-C200P   Rev.5 

20 /

 

[Top Cover Assy]

Figure 2-2

 

For 600dpi