Sharp LL-P202V (serv.man2) Service Manual ▷ View online
LL-P202V/S242A IMPORTANT INFORMATION FOR SERVICING THE DISPLAY AND SOFTWARE 3 - 12
■ UPDATE VERSION PROCEDURE
1) Change PC and Touch monitor into connection state. Version information is displayed when it is connected normally.
2) Push the VersionUP button, the following message box will be displayed.
3) Push [OK] button, the following progress screens will be displayed and upgrade will be performed.
4) If upgrade is successful, the following messages will be displayed and Touch monitor will reboot automatically.
■Notes during the upgrade
Please follow the following notes during upgrade.
(1) Don't take out the any cable.
(2) Don't turn off power during upgrade.
(3) Don't operated PC during upgrade.
(4) Don't operated Touch monitor during upgrade.
LL-P202V/S242A IMPORTANT INFORMATION FOR SERVICING THE DISPLAY AND SOFTWARE 3 - 13
3-7. MODEL SETTING
■OUTLINE
When the board is exchanged by board failure, it is necessary to set the model. The model which can be set up is the following three kinds.
- LL-P202V
- LL-S242A
However, it can change only into the model of the same size as a model setup before change. For example, when the present model setup
is LL-S242A, the model which can be set up serves as LL-S242A
Only the model which can be set up is displayed combo box.
■How to operate
(1)
(2)
(3)
LL-P202V/S242A IMPORTANT INFORMATION FOR SERVICING THE DISPLAY AND SOFTWARE 3 - 14
1) Push the Connect button and change PC and Touch monitor into a connection state.
2) Choose the model to set up from combo box in the item of [Model].
3) Push the Change button in the item of [Model].
4) Since the confirmation message of the purport that Touch monitor is rebooted is displayed, check that it is in the situation which may
reboot and click OK.
Memo: If clicked cancel, model setup is not performed.
5) When it succeeds, the following message box will be displayed.
LL-P202V/S242A IMPORTANT INFORMATION FOR SERVICING THE DISPLAY AND SOFTWARE 3 - 15
3-7. DESTINATION SETTING
■OUTLINE
When the board is exchanged by board failure, it is necessary to set the destination. It can set up destination where there are five kinds,
Japan, North America, Europe, Europe2( Russia / Italy) and Australia / New Zealand.
■HOW TO SET
1) Push the Connect button and change PC and Touch monitor into a connection state.
2) Choose the destination as JP(0) / US(1) / EU(2) / RUS, ITA(3) / AU, NZ(4) in the item of [Region].
3) Push the Change button in the item of [Region].
4) When it succeeds, the following message box will be displayed.
(1)
(2)
(3)
Click on the first or last page to see other LL-P202V (serv.man2) service manuals if exist.