Sharp UP-3300 (serv.man20) User Manual / Operation Manual ▷ View online
67
• ER-04RP
Physical characteristics
Control panel
Online switch
Paper outlet
Ribbon cover
AC power receptacle
Power switch
Line feed switch
SRN connector
Paper cover
68
1. Lamps and switches
(1) Lamps
• Power lamp
This lamp lights up when the power switch of the remote printer is turned on.
• Online lamp
This lamp lights up when the online switch is pressed, and goes off when the switch is
pressed again.
• Alarm lamp
This lamp lights up when the remote printer malfunctions. In this case the printer neither
prints any data nor feeds the paper. The alarm state can be cleared by pressing the
online switch or by setting the power switch to the OFF position and then back to the ON
position.
(2) Switches
• Power switch
This switch is used to energize the remote printer.
• Online switch
This switch is used to make the remote printer perform printing.
It must be pressed before starting registrations which require printing.
• Line feed switch
This switch is used to advance the paper in the remote printer.
2. Replacement of the paper roll
When a colored dye appears on the paper roll, it means that it is time to replace the existing
paper roll. Replace the paper roll with a new one according to the procedures described below.
When installing a paper roll for the first time, take steps 1 and 4 through 7.
1.
Pull up the paper cover and remove it.
69
2.
Cut the paper along a straight line to remove the
paper spool.
3.
Press the line feed switch to remove the paper
remaining in the printer.
4.
Fold the top end of the replacement paper roll by 3 to
5 cm securely as shown at left.
5.
Insert the end of the folded paper deep into the paper
chute of the printer and press the line feed switch to
advance the paper.
NOTE
If paper is not inserted deep enough, it will not
advance when the line feed switch is pressed.
3 to 5 cm
How to fold paper
70
6.
Take up the slack in the paper and set the roll in
position.
7.
Close the paper cover.
3. Replacement of the ink ribbon cassette
When the print becomes faint, replace the ink ribbon cassette with a new one according to the
procedures described below.
Be sure to turn off the remote printer before replacing the ink ribbon cassette.
1.
Remove the paper cover and the ribbon cover.
Click on the first or last page to see other UP-3300 (serv.man20) service manuals if exist.