Sharp UP-3300 (serv.man20) User Manual / Operation Manual ▷ View online
63
1. Lamps and switches
(1) Lamps
• Power lamp
This lamp lights up when the power switch of the remote printer is turned on.
• Online lamp
This lamp lights up when the online switch is pressed, and goes off when the switch is
pressed again.
• Alarm lamp
This lamp lights up when the remote printer malfunctions. In this case the printer neither
prints any data nor feeds the paper. The alarm state can be cleared by pressing the
ONLINE switch or by setting the power switch to the OFF position and then back to the
ON position.
(2) Switches
• Power switch
This switch is used to energize the remote printer.
• Online switch
This switch is used to make the remote printer perform printing.
It must be pressed before starting registrations which require printing.
• Line feed switch
This switch is used to advance the paper in the remote printer.
2. Replacement of the paper roll
When a colored dye appears on the paper roll, it means that it is time to replace the existing
paper roll. Replace the paper roll with a new one by using the procedures described below.
When installing a paper roll for the first time, take steps 1 and 4 through 7.
1.
Pull up the paper cover and remove it.
64
2.
Cut the paper along a straight line to remove the
paper spool.
3.
Press the line feed switch to remove the paper
remaining in the printer.
4.
Fold the top end of the replacement paper roll by 3 to
5 cm securely as shown at left.
5.
Insert the end of the folded paper deep into the paper
chute of the printer and press the line feed switch to
advance the paper.
NOTE
If paper is not inserted deep enough, it will not
advance when the line feed switch is pressed.
3 to 5 cm
How to fold paper
65
6.
Take up the slack in the paper and set the roll in
position.
7.
Pass the top end of the paper through the paper cutter
on the paper cover and close it.
3. Replacement of the ink ribbon cassette
When the print becomes faint, replace the ink ribbon cassette with a new one according to the
procedures described below.
Be sure to turn off the remote printer before replacing the ink ribbon cassette.
1.
Pull up the ribbon cover and remove it.
66
2.
Rotate the take-up knob of the ink ribbon cassette in
the direction of the arrow to tighten the ink ribbon.
3.
Push the ink ribbon cassette to the left, then lift up its
right side to remove it.
4.
Rotate the take-up knob of the new ink ribbon
cassette to tighten the ink ribbon. Install the new ink
ribbon cassette so that the ink ribbon sets into the gap
between the dot head nose assembly and paper guide
as shown at the left.
5.
Close the ribbon cover.
Ink ribbon
cassette
cassette
Take-up knob
Ink ribbon
Click on the first or last page to see other UP-3300 (serv.man20) service manuals if exist.