DOWNLOAD Sharp DV-L80 (serv.man18) Service Manual ↓ Size: 2.27 MB | Pages: 113 in PDF or view online for FREE

• The battery capacity indicator appears only while the display mode is “on”. The

indicator appears for a short while and then disappears.

• Battery condition, temperature, and operational conditions affect the

remaining capacity of a battery. Because of this the battery capacity
indicator is intended to be for reference purposes only.

• Regardless of the display mode, the low battery warning appears on the

display whenever the battery is about to go dead.

• The low battery warning does not appear when the display panel is closed.

When the POWER (G)/CHARGE(R) lamp flashes green, replace the battery
pack with a charged one or switch to AC adapter power.

• The low battery warning is being displayed until the battery goes dead. When the

battery goes dead, the POWER(G)/CHARGE(R) lamp turns off. When this
happens, replace the battery pack with a charged one or switch to AC adapter
power.

➜

➜

Full charge

Low

Flashing

• Each press of OPERATE toggles power on and off.
• In the following cases, the POWER (G)/CHARGE (R) lamp on the front of the

Player lights green to let you know that power is on. This helps to ensure you
do not forget and leave power on.
1 When the display panel is closed with the Player’s power turned on
2 When the LCD display setting is “off” (see page 67)

• Auto Power Off automatically turns off power when you leave the Player in

the DVD mode without a disc inserted or when playback is stopped for
more than 5 minutes.
Power is also turned off if no signal is received for more than 5 minutes in
INPUT mode.

• When not in use, unplug the AC adapter from the power outlet.
• The power supply circuit performs an initialization routine immediately after you

connect the AC adapter or a battery pack. Because of this, you should wait for
about three seconds before turning on power.

+

POWER (G)/
CHARGE (R) lamp

Press 
OPERATE.

For the U.K.
and Eire

• Do not subject the Remote to

strong impact.

• Do not allow the Remote to become

wet and keep it out of areas subject
to high humidity.

• The Remote may fail to work properly after

you replace its battery. When this happens,
remove the battery and leave it out for at
least five minutes. Next, reload the battery
and try again.

• The Remote may not work properly if the

remote sensor of the Player is in direct
sunlight or other strong light. Change the
orientation of the light or the Player and try
again.

• If you do not plan to use the Remote for a long time, remove its battery.

Holding the release tab to the
left, slide the battery holder from
the Remote with your fingernail
catching the slit.

Place a lithium battery into the
battery holder and slide the
battery holder back into place.
• Make sure the 

 side of the

battery is facing in the same
direction as the 

 mark on

the battery holder. The
remote control will not
operate correctly if you insert
the battery upside-down.

+

POWER(G)/CHARGE(R)

RETURN

ENTER

OPEN

PUSH TO 

CLOSE

OPERATE

INPUT/DVD

SETUP/ADJ.

SHIFT

–      VOLUME      +

5m

15

°

15

°

Remote sensor

Signal emitter

Release tab

slit

REPLACE BATTERY WITH TOSHIBA OR HITACHI MAXELL TYPE CR2025
ONLY. USE OF ANOTHER BATTERY MAY PRESENT A RISK OF FIRE OR
EXPLOSION.

• KEEP THIS BATTERY AWAY FROM CHILDREN. IF SWALLOWED,

CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT.

• BATTERY MAY EXPLODE IF MISTREATED. DO NOT RECHARGE,

DISASSEMBLE OR DISPOSE OF IN FIRE.

• Do not short-circuit, recharge, disassemble, or heat the lithium battery.
• Should the lithium battery leak, wipe the battery compartment and holder

clean, and then insert a new battery.

• The lithium battery will last about six months to one year of normal usage.
• Purchase the Remote’s replaceable lithium battery from your Sharp autho-

rized service centre.