Sharp DV-L70 (serv.man27) User Manual / Operation Manual ▷ View online
GB
38
To turn main power on and off
•
Slide the main power switch left to the “ON” position to turn power on.
•
Slide the main power switch right to the “OFF” position to turn power
off.
off.
• In the following cases, the power/standby lamp on the front of the DVD
player lights green to let you know that power is on. This helps to ensure you
do not forget and leave power on.
1 When the display panel is closed with main power turned on
2 When the backlight setting is “OFF” (see page 82)
do not forget and leave power on.
1 When the display panel is closed with main power turned on
2 When the backlight setting is “OFF” (see page 82)
• When not in use, unplug the AC adapter from the power outlet.
Turning Power On and Off
ON/S
TAN
DBY
POWER ON
OFF
POWER ON
OFF
For the U.K.
and Eire
and Eire
Power/standby lamp
Main power switch on
Main power switch off
39
GB
To turn power on and off with the remote control unit
When the main power switch is in the “ON” position, you can turn power off
and on by pressing
and on by pressing
OPERATE
.
1
Press OPERATE.
• Each press of
OPERATE
toggles power on and off.
• Pressing
OPERATE
does not turn on power if the main power switch is
in the “OFF” position.
• After DVD player power is turned off using
OPERATE
, the power/
standby lamp is red to indicate the DVD player is in the Standby mode.
Standby mode
In the Standby mode, the power/standby lamp is red, regardless of whether
the display panel is open or closed. The DVD player goes into the Standby
mode when either of the following happens.
the display panel is open or closed. The DVD player goes into the Standby
mode when either of the following happens.
• When you press
OPERATE
• When disc play is stopped for about five minutes in the DVD mode
To restore full power from the Standby mode, press
RETURN
on the player,
slide the main power switch to the “OFF” position and then back to “ON” again,
or press
or press
OPERATE
.
Turning Power On and Off
OPERATE
TITLE
ENTER
MENU
RESUME
STOP
STILL/PAUSE
REPEAT
PROGRAM
DIRECT
CLEAR
MEMORY
SKIP
PLAY
SKIP
SLOW
FWD
REV
DISPLAY
RETURN
VIRTUAL
BACKLIGHT
HI/LOW/OFF
VIEW
MODE
DIGITAL
GAMMA
DIGITAL
S.PICTURE
VIDEO
ADJUST
OPERATE
VO
LU
ME
VI
DE
O
AU
DI
O
OP
TIC
AL
A
NA
LO
G
PH
ON
ES
MA
X
MIN
ON/S
TAN
DBY
INPUT/
DVD
BACKLIGHT
HI/LOW/OFF
VIEW
MODE
SKIP
PLAY/GUI
SKIP
STOP
TITLE
MENU
ENTER
RETURN
OPEN
STILL/P
AUSE
Power/standby lamp
RETURN
GB
40
To load batteries
For information about how to load the batteries, see page 17.
Using the Remote Control Unit
Remote control unit operating range
Important!
• Do not subject the remote control
unit to strong impact.
• Do not allow the remote control unit
to become wet and keep it out of
areas subject to high humidity.
areas subject to high humidity.
• The remote control unit may fail to work
properly after you replace its batteries. When
this happens, remove the batteries and leave
them out for at least five minutes. Next, reload
the batteries and try again.
this happens, remove the batteries and leave
them out for at least five minutes. Next, reload
the batteries and try again.
• The remote control unit may not work properly
if the remote sensor of the DVD player is in
direct sunlight or other strong light. Change
the orientation of the light or the DVD player
and try again.
direct sunlight or other strong light. Change
the orientation of the light or the DVD player
and try again.
OPERATE
TITLE
ENTER
MENU
RETURN
VIRTUAL
BACKLIGHT
HI/LOW/OFF
VIEW
MODE
DIGITAL
GAMMA
DIGITAL
S.PICTURE
VIDEO
ADJUST
15
°
15
°
Remote sensor
Signal emitter
5m
Improperly using batteries can cause them to leak. Note the following
precautions when using batteries.
precautions when using batteries.
CAUTION
• Make sure the positive
and negative
ends of the batteries are
facing correctly.
• Never mix batteries of different types.
• Never mix new batteries with old ones. Doing so reduces the life of the
• Never mix new batteries with old ones. Doing so reduces the life of the
new batteries and can cause the old batteries to leak.
• Do not leave dead batteries in the remote control unit. Touching fluid
leaking from batteries can cause skin irritation. Clean out any leaked fluid
with a cloth, taking care not to get any on your fingers.
with a cloth, taking care not to get any on your fingers.
• The batteries that come with the DVD player discharge slightly during shipping
and storage. You should be able to get about six months to one year of operation
from the supplied batteries.
from the supplied batteries.
• If you do not plan to use the remote control unit for a long time, remove its batteries.
41
GB
Your DVD player has two operation modes. Select the one that suits the
operation you want to perform.
• DVD mode for disc playback
• INPUT mode for input from external equipment
operation you want to perform.
• DVD mode for disc playback
• INPUT mode for input from external equipment
To select an operation mode
1
Slide the main power switch towards “ON” to turn on power.
2
Press INPUT/DVD.
• Each press of
INPUT/DVD
toggles between the DVD mode and the
INPUT mode.
INPUT
Operation Modes
INPUT Mode
DVD Mode
ON/S
TAN
DBY
INPUT/
DVD
BACKLIGHT
HI/LOW
/OFF
VIEW
MODE
SKIP
PLAY/G
UI
SKIP
STO
P
TITLE
MENU
ENTER
RETU
RN
OPEN
STILL/PAUSE
VO
LU
ME
VI
DE
O
AU
DI
O
OP
TIC
AL
A
NA
LO
G
PH
ON
ES
MA
X
MIN
INPUT/
DVD
DVD
POWER ON
OFF
Click on the first or last page to see other DV-L70 (serv.man27) service manuals if exist.