Sharp AY-XP13CR (serv.man15) Service Manual ▷ View online
37
AY-XP08CR
AY-XP10CR
AY-XP13CR
AY-XP10CR
AY-XP13CR
DUST SENSOR
GAS SENSOR
THERMISTOR
CN101 and CN102
5. Remove 2 connectors.
6. Pull the board.
Drain pan and related
1. Remove 3 screws fixing motors.
2. Turn the cap area of the drain hose counterclockwise,
and remove it from the drain pan.
During installation, turn the drain hose to the state of
the “engagement position”.
After reinstallation, verify that it is securely fastened.
During installation, turn the drain hose to the state of
the “engagement position”.
After reinstallation, verify that it is securely fastened.
How to remove the horizontal louver
Slightly pull down the hinge area, deflect the louver, and
unhook it from the hinge. Remove the shaft from each of
the left and right sides.
Slightly pull down the hinge area, deflect the louver, and
unhook it from the hinge. Remove the shaft from each of
the left and right sides.
Drain pan
Drain Hose
Groove
Projection
To disconned
To reconnect
How to remove the HI VOLTAGE UNIT.
1. Remove the HIGH VOLTAGE UNIT.
1. Remove the HIGH VOLTAGE UNIT.
(Press and spread the hook, and HI VOLTAGE will
be ready for removal.)
be ready for removal.)
How to remove the DUST SENSOR, the THERMISTOR
and the GAS SENSOR.
Remove the DUST SENSOR, the THERMISTOR, and
the GAS SENSOR.
and the GAS SENSOR.
Remove the DUST SENSOR, the THERMISTOR, and
the GAS SENSOR.
(Press and spread the hook,and GAS SENSOR will be
ready for removal)
ready for removal)
How to remove the display board unit 2.
The display board unit 2 is pushed in the direction of
arrow 1 .
And it is made to slide in the direction of arrow 2 , and
remove.
The display board unit 2 is pushed in the direction of
arrow 1 .
And it is made to slide in the direction of arrow 2 , and
remove.
display board unit2
1
2
38
AY-XP08CR
AY-XP10CR
AY-XP13CR
AY-XP10CR
AY-XP13CR
FOR OUTDOOR UNIT [AE-X08CR / AE-X10CR / AE-X13CR]
CAUTION : DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE ANY
SERVICING
1. Loose a screw fixing the side cover.
Right side view
Left side view
Right side view
Left side view
Front view
2. Loose the unit to unit cord.
3. Loose a screw fixing the cord clamp.
4. Loose 4 screws fixing the top panel.
5. Loose 6 screws fixing the front panel.
6. Cut 4 nylon bands.
7. Disconnect following connectors and each wire.
Choke coil(two terminal)
Fan motor
Thermistor
Reverse valve
Fan motor
Thermistor
Reverse valve
39
AY-XP08CR
AY-XP10CR
AY-XP13CR
AY-XP10CR
AY-XP13CR
8. Remove the terminal cover of compressor.
9. Remove 3 terminals of compressor..
10. Loose 4 screws fixing the control box.
11. Take out the control box.
DISASSEMBLING PROCEDURE OF THE FAN
1. Loose the fan nut and fan can take out.
2. Fan motor is secured by 4 screws.
Loose
40
AY-XP08CR
AY-XP10CR
AY-XP13CR
AY-XP10CR
AY-XP13CR
OPTION
1
Take out the air filters.
Open the open panel.
Push the air filters up slightly to unlock
them.
Pull the air filters down to remove
Push the air filters up slightly to unlock
them.
Pull the air filters down to remove
Take of the old dust collection filter
and the deodorant filter from the air filter.
Snap out in the arrow marked direction.
Set the new dust collection filter and
the deodorant filter with filter stoperts
located on the air filters.
and the deodorant filter from the air filter.
Snap out in the arrow marked direction.
Set the new dust collection filter and
the deodorant filter with filter stoperts
located on the air filters.
them.
2
Check the filters.
3
Reinstall the air filters
Reinstall the air filters in the original
positions.
Close the open panel.
Push the arrow-marked of the panel
firmly to lock it in place.
positions.
Close the open panel.
Push the arrow-marked of the panel
firmly to lock it in place.
DUST COLLECTION FILTER (gray)
Set the black side facing upward.
Filter stopper
DEODORANT FILTER (green)
Filter stopper
2
1
3
3
1
2
HOW TO REPLACE THE
DUST COLLECTION FILTER AND DEODORANT FILTER
DUST COLLECTION FILTER AND DEODORANT FILTER
(only for models AY-XPM7CR/AY-XPM9CR/AY-XPM12CR)
Precautions
The dust collection filter and the deodorant filter are packed as accessory of this unit.
During operation of the air conditioner, the filters remove dust and tobacco smoke
from the air and discharges clean air.
• The filters are sealed in a plastic bag to keep their dust collection effect.
Do not open the bag until using the filters. (Otherwise the filters life may get shorter.)
• Do not expose the filters to direct sunlight. (Otherwise they may deteriorate.)
The dust collection filter and the deodorant filter are packed as accessory of this unit.
During operation of the air conditioner, the filters remove dust and tobacco smoke
from the air and discharges clean air.
• The filters are sealed in a plastic bag to keep their dust collection effect.
Do not open the bag until using the filters. (Otherwise the filters life may get shorter.)
• Do not expose the filters to direct sunlight. (Otherwise they may deteriorate.)
1
3
2
1
1
3
2
2
Click on the first or last page to see other AY-XP13CR (serv.man15) service manuals if exist.