DOWNLOAD Sharp AY-XP13CR (serv.man15) Service Manual ↓ Size: 4.26 MB | Pages: 48 in PDF or view online for FREE

33

1. Open the opne panel, and remove 2 air filters.

2. Remove 4 screws fixing the front panel.

3. Remove the screw fixing the cord clamp.
Note :
During reassembly, install the holder after installing the
front panel. This will make it
easier to assemble the front panel.

4. Close the open panel. Pushing the nail of the front

panel.

5. Pull the front panel up.

6. Remove the unit-to-unit wiring from the terminal

board.

7. Remove a screw fixing the control box cover, and

remove it.

8. Remove 2 screws fixing the 2 ground wires and

terminal.

Note :
During reassembly, take care direction of the lead wires.

34

CN1

CN5

CN4

CN3

9. Remove 2 screws fixing the sensor holder, lead cover

A and lead cover B from the evaporator.

10.Cut off 3 fixing bands.

During reassembly, fix them by fixing bands as same
certainly.

11. Remove 2 thermistors of the evaporator and the pipe.

13. Pushing the 2 hooks of the holder, remove the

display board unit 3 from the holder.
And remove 2 screws fixing the cluster holder from
the drain pan.

12.Remove 4 conectors.

14.Remove 3 screws fixing the LED HOLDER B

15. Remove the screw fixing the pipe holder.

16. Remove 3 screws fixing the control box,and remove

the control box.

35

17. Remove a screw fixing the drain pan.

18. Pull the drain pan toward you.

19. Remove the drain cover from the evaporator.

20. Remove 4 screws fixing the evaporator.

21. Remove the evaporator from the cabinet.

22. Remove 3 screws fixing the motor cover, and pull up

the fan.

23.Loose a screw fixing fan.

36

[Cautionary points for assembling the fan]
a. When inserting the motor shaft into the metal fan

boss, take care to prevent injuring the inner surface of
the metal fan boss.

b. Before fastening the motor shaft and fan, insert the

motor shaft into the metal fan boss until it stops.

1. Push the center of display cover from the back.
2. Slide the display cover to the right.

2. After the left half is inseted completely, press the

display cover and snap in the 2 or 3 hooks on the
right.

1. Remove the photo detector unit.

(Press and spread the upper hook, and the photo
detector unit will be ready for removal.)

2. Remove the screw fixing the terminal board.

Fan motor

Motor shaft

Fan boss

Cross flow fan

1

2

3. Remove 2 screws fixing the board (transformer).

1. Slide the left end of the display cover through 2 hooks

on the front panel along the guide from the center of
the front panel.

4. Remove 5 connectors. And cut off a fixing band.

CN8

CN10

CN6

CN9

CN7