Panasonic TX-40CS620E / TX-40CSR620 / TX-40CSR625 Service Manual ▷ View online
Applicable Signals
Note:
Signals other than above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.
Signal name
COMPONENT
HDMI
525 (480) / 60i,60p
*
*
625 (576) / 50i, 50p
*
*
750 (720) / 60p, 50p
*
*
1,125 (1,080) / 60i, 50i
*
*
1,125 (1,080) / 60p
*
1,125 (1,080) / 50p
*
1,125 (1,080) / 24p
*
Component (Y, Pb, Pr) (from AV2 terminal), HDMI
10
Specifications
Power
Source:
220-240V AC, 50 / 60Hz
Rated Power Consumption:
62W
Stand-by Power Consumption: 0.20W
Aerial
Impedance: 75
unbalanced, Coaxial Type
Receiving System:
40CS620E
DVB-T/T2 Digital terrestrial services (
MPEG2 and MPEG4-AVC(H.264)
)
DVB-C
Digital cable services (
MPEG2 and MPEG4-AVC(H.264)
)
PAL I/H, B/G,
SECAM B/G, L/L’
VHF E2-E12 VHF H1-H2 ( ITALY )
VHF A-H ( ITALY ) UHF E21-E69
CATV (S01-S05) CATV S1-S10(M1-M10)
CATV S11-S20 (U1-U10) CATV S21-S41 (HYPERBAND)
PAL D/K,
SECAM
D/K
VHF R1-R2 VHF R3-R5
VHF R6-R12 UHF E21-E69
PAL 525/60 (AV only)
M.NTSC (AV only)
NTSC (AV only)
40CSR620, 40CSR625
DVB-T/T2 Digital terrestrial services (
MPEG2 and MPEG4-AVC(H.264)
)
DVB-C
Digital cable services (
MPEG2 and MPEG4-AVC(H.264)
)
PAL D/K
SECAM
D/K
VHF R1-R2 VHF R3-R5
VHF R6-R12 UHF E21-E69
PAL 525/60 (AV only)
M.NTSC (AV only)
Aerial - Rear:
VHF/UHF
Operating Conditions:
Temperature: 0°C
35°C
Humidity:
20%
80% RH (non condensing)
Terminals:
AV1 IN
Video (21 pin)
1V p-p 75
Audio (21 pin)
500mV rms 10k
RGB (21 pin)
0.7V p-p 75
AV1 OUT
Video (21 pin)
1V p-p 75
Audio (21 pin)
500mV rms 1k
AV2 IN
Video (RCAx1)
1V p-p 75
(COMPONENT/VIDEO)
Audio (RCAx2)
500mV rms 10k
(used for HDMI_ AV2 audio IN)
Video (RCAx3)
Y:1V p-p 75
(including synchronisation)
Pb/Cb, Pr/Cr: ±0.35V p-p 75
HDMI1, HDMI2, HDMI3
Type A Connectors
HDMI
1/3 : Content Type
HDMI 2 : Content Type, Audio Return Channel
This TV supports “HDAVI Control 5” function.
DIGITAL AUDIO OUT
PCM / Dolby digital, Fibre optic
USB 1/2
DC 5V, Max 500mA [Hi-Speed USB (USB 2.0)]
ETHERNET
RJ45, IEEE802.3 10BASE-T / 100BASE-TX
CARD SLOT
Common interface slot (Complies with CI+) x 1
11
Wireless LAN:
Standard Compliance
IEEE802.11a/n , IEEE802.11b/g/n
Frequency
Range
40CS620E
IEEE802.11a/n: 5.180 GHz – 5.320 GHz
5.500 GHz – 5.580 GHz
5.660 GHz – 5.700 GHz
IEEE802.11b/g/n: 2.412 GHz – 2.472 GHz
Frequency
Range
40CSR620, 40CSR625
IEEE802.11a/n: 5.15 GHz – 5.35 GHz
5.47 GHz – 5.85 GHz
IEEE802.11b/g/n: 2.400 GHz – 2.4835 GHz
Security WPA2-PSK
(TKIP/AES)
WPA-PSK
(TKIP/AES)
WEP(64
bit/128
bit)
LCD screen: L5EDDYY00764
1920
x
1080,
16:9
Visible
Diagonal
1000mm
Audio
Output:
20W (2 x 10W)
Headphones:
3.5mm,
8
Impedance
Accessories supplied :
Remote Control
2 x R6 (UM3) Batteries
Dimensions:
Width: Height: Depth:
Including TV stand
904mm 560mm 202mm
TV set only
904mm 518mm 47mm
Mass:
Including TV stand
12.0kg
TV set only
10.5kg
Design and Specifications are subject to change without notice. Mass and dimensions shown are approximate.
This equipment complies with the EMC standards listed below:
EN55032, EN55020, EN55024, EN61000-3-2, EN61000-3-3
12
Technical Description
Specification of KEY for DTCP-IP, C2MOD, CI Plus, DIMORA, HDCP2, Netflix, Widevine,
Freetime
General information:
Freetime
General information:
1. eMMc Memory(IC8903) for spare parts has the seed of KEY for each.
2. The final KEY data will be generated by LD6 IC (IC8000) when SELF CHECK was done and are stored in both
LD6 IC (IC8000) and eMMc (IC8903).
All KEYs are not generated for all models.
The necessary KEY are only generated and stored depend on the feature of models.
2. The final KEY data will be generated by LD6 IC (IC8000) when SELF CHECK was done and are stored in both
LD6 IC (IC8000) and eMMc (IC8903).
All KEYs are not generated for all models.
The necessary KEY are only generated and stored depend on the feature of models.
Replacement of ICs:
When LD6 IC (IC8000) is replaced, eMMc (IC8903) should be also replaced with new one the same time.
When eMMc Memory(IC8903) is replaced, LD6 IC (IC8000) is not necessary to be replaced the same time.
After the replacement of IC, SELF CHECK should be done to generate the final KEY data.
How to SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press the MENU button on the remote
control for more than 3 seconds.
TV will be forced to the factory shipment setting after this SELF CHECK.
When eMMc Memory(IC8903) is replaced, LD6 IC (IC8000) is not necessary to be replaced the same time.
After the replacement of IC, SELF CHECK should be done to generate the final KEY data.
How to SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press the MENU button on the remote
control for more than 3 seconds.
TV will be forced to the factory shipment setting after this SELF CHECK.
Model and Keys:
Model No.
Keys
DTCP-IP C2MOD CI
PLUS DIMORA
HDCP2
Netflix
Widevine
FREETIME
TX-40CS620E Yes None Yes
Yes
Yes
Yes
None
TX-40CSR620 None None Yes Yes Yes Yes None
TX-40CSR625 None None Yes Yes Yes Yes None
TX-40CSR625 None None Yes Yes Yes Yes None
13
Click on the first or last page to see other TX-40CS620E / TX-40CSR620 / TX-40CSR625 service manuals if exist.