DOWNLOAD Panasonic KX-TGK310RUB / KX-TGK320RUB / KX-TGKA31RUB Service Manual ↓ Size: 7.69 MB | Pages: 94 in PDF or view online for FREE

17

: inside of Handset

: KX-TGK320 only

*1

*1

*1

*1

---ANT. - <BASE_UNIT_RF_RX_ROUTE> - IC501(46/47 - 28) - L101 - C184 - Q161 - Q141 
- D101 - P101 - T/R(TEL LINE)

T/R(TEL LINE) - P101 - D101 - Q141 - Q161 - R164 - R177 - C173 - Q171 - C178 
- IC501(16 - 44/45) - <BASE_UNIT_RF_TX_ROUTE> - ANT. ---

---ANT. - <BASE_UNIT_RF_RX_ROUTE> - IC501(46/47 - 28) - L101 -  C184 - Q161 - Q141 
- D101 - P101 -T/R(TEL LINE)

T/R(TEL LINE) - P101 - D101 - Q141 - Q161 - R164 - R177- C173 - Q171 - C178 - R178 
- IC501(16-44/45) - <BASE_UNIT_RF_TX_ROUTE> - ANT. ---

---ANT. - <BASE_UNIT_RF_RX_ROUTE> - IC501(46/47- 73/74) - IC601

IC601 - IC501(73/74 - 28) - L101 - C184 - Q161 - Q141 - D101 - P101 
- T/R(TEL LINE)

T/R(TEL LINE) - P101 - D101 - Q141 - Q161 - R164 - R177- C193 - Q171 - C178 - R178 
- IC501(16 - 73/74) - IC601

IC501(28) - L101 - C184 - Q161 - Q141 - D101 - P101 - T/R(TEL LINE)

T/R(TEL LINE) - P101 - C121/C122 - R121/R122 - IC501(24/25)

T/R(TEL LINE) - P101 - R111/R112 - C110/C112 - Q111 - IC501(5)

HANDSET TX

HANDSET RX

HANDSET 
SP-Phone TX

HANDSET 
SP-Phone RX

SIGNAL ROUTE

IN 

䊻㻌

ROUTE 

䊻㻌

OUT

GREETING
RECORDING

GREETING PLAY
TO TEL LINE

ICM RECORDING

DTMF SIGNAL 
TO TEL LINE

CALLER ID

BELL DETECTION

MIC (+) -  C13  - 

IC1 (17)         IC1(86) 

MIC (–) -  C11  - 

IC1 (18)           IC1(87) 

C859   - ANT to BASE

from BASE UNIT   ANT 1

IC1 (1)
IC1 (2)

IC1 (21) - RECEIVER (+)
IC1 (22) - RECEIVER (–)

MIC (+) -  C13  - 

IC1 (17)         IC1(86) 

MIC (–) -  C11  - 

IC1 (18)           IC1(87) 

C859  - ANT to BASE

from BASE UNIT   ANT  –– IC1 (1) ––– IC1 (35) - SP (–)

   – IC1 (2) –  – IC1 (37) - SP (+)

MIC (+) -  C13  - 

IC1 (17)

        IC1(86) 

MIC (–) -  C11  - 

IC1 (18)          

IC1(87) 

C859   - ANT to BASE

RA4 - 

RA4 - 

RA4 - 

RA4 - 

RA4 - 

RA4 - 

18

SIGNAL ROUTE

IN 

䊻㻌

ROUTE 

䊻㻌

OUT

 IC1(86/87) - C859 -  ANT

ANT - IC(1/2)

 IC501(44/45) - C819 - ANT

ANT - C895 - IC501(46/47)

: inside of Handset

19

Refer to the Operating Instructions.

You can download and refer to the Operating Instructions (Instruction book) on TSN Server.

Refer to the Operating Instructions.

You can download and refer to the Operating Instructions (Instruction book) on TSN Server.

Refer to the Operating Instructions.

You can download and refer to the Operating Instructions (Instruction book) on TSN Server.

(right soft key)     

132

Items

Contents

Battery

You could use other rechargeable batteries sold in a market, but the unit is not guaranteed to work 
properly.

The battery strength may not be indicated correctly if the battery is disconnected and connected again, 
even after it is fully charged. In that case, by recharging the battery as mentioned in the Operating 
Instructions, you will get a correct indication of the battery strength.

PIN Code

Recall

Earth Recall feature is not supported in this model.

L Change the PIN using the following method.

7

Enter the new 4-digit base unit PIN. 

i

{OK} 

#

{ ^^ } : “ Yes” 

i

{OK}

i

 

{

c

}

} 

20

     

Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.

9). Press                            to return to standby mode.          

          After that, turn the base unit power off and then power on.

2).   Select "Initial Setup" using       or            

       then press  

{

OK

}

.

{^}

4).   Enter "7", "2", "6", "2", "7", "6", "6", "4".

       Note: 7262 7664 = PANA SONI 

                (see letters printed on dial keys)

6).   Enter " ", " ", " ", " " (Address). (*1)

7).   Enter " ", " " (New Data). (*1)

5).   Select "Write EEP" using      or     

       then press 

 or 

{>}

.

3).   Select "Line Setup" using      or     

then press 

{

OK

}

 or 

{>}

.

_ _ _ _   _ _

Set Addr.:

 

Default Data

Set Addr.:

C

New Data

Set Addr.:

C

8).   Press         , a long confirmation beep 

       will be heard.

{

OK

}

Service Mode

 Read EEP

 

Write EEP

{

OK

}

Get S/W Ver.

{

}

1).   Press          .

{

}

{ }(Off/Power)

{

}

{V}

{^}

{V}

{^}

{V}

{ }(Off/Power)

OK

OK

OK