DOWNLOAD Panasonic KX-TG8095RUJ / KX-TG8095RUS / KX-TG8095RUT / KX-TGA807RUJ / KX-TGA807RUS / KX-TGA807RUT / KX-TGA809RUS / KX-TGA809RUT Service Manual ↓ Size: 2.65 MB | Pages: 69 in PDF or view online for FREE

5

There are several types of PbF solder available commercially. While this product is manufactured using Tin, Silver, and Copper
(Sn+Ag+Cu), you can also use Tin and Copper (Sn+Cu) or Tin, Zinc, and Bismuth (Sn+Zn+Bi). Please check the manufacturer’s
specific instructions for the melting points of their products and any precautions for using their product with other materials. 
The following lead free (PbF) solder wire sizes are recommended for service of this product: 0.3 mm, 0.6 mm and 1.0 mm.

When discarding P. C. Board, delete all personal information such as telephone directory and caller list or scrap P. C. Board.

6

• Specifications are subject to change.

• Operation range: Up to 300 m outdoors, Up to 50 m indoors, depending on the condition.
• Analog telephone connection: Telephone Line

7

3.3 V

3.3 V

40

6

18

4

20

Q604, Q17

R-D

A

T

A

T

-D

ATA

D1~ D4, Q7

45

22, 23

67, 68

6, 58, 69, 81

13.824 MHz

KX-TG8095 BLOCK DIA

GRAM 

(BASE UNIT)

72~76

1~3, 87, 88

25, 26

81, 4

8

The base unit consists of base band controller, speech network, tel-line interface, EEPROM, RF module, linear regulator, crys-
tal and so on. Refer to Block Diagram (Base Unit) (P.7).

BBIC (U4) controls all functions of the base unit. This device includes all control circuits of the base unit for RF module, tel-line
interface, ADPCM codec, series regulator and so on. 

The power supply is generated by voltage regulator (U1). 
U1 generates DC 3.3V voltage from DC 6V voltage of adaptor output. DC 3.3V is used for RF module & I/O port, DC 2.5V &
DC1.8V are used for the base band controller and the circumference circuits.

The TR circuit is used for speech network. The function of this connects tel-line interface and the base band controller.

The function of this connects tel-line and speech network. Also, the tel-line interface includes the ring detect circuit, caller-ID cir-
cuit.

This is 128K bits memory. The each kind of value to set-up at power-on, caller list memory and so on are stored in this device.

Receiver part: RF signals induced at the antenna are extracted by the RF control interface. The RF signal to be selected is
demodulated into RX_DATA signals. And the signals are passed to the base band controller.
Transmitter part: The signal from transceiver chip-set is fed to the antenna through the RF power amplifier by control of the RF
control interface. And then this signal is radiated from antenna.
Logical part: The frequency to be used is generated in transceiver chip-set by control signals (CLK, DATA, ENABLE, SYRI) of
the RF control interface.

8 M bytes non-volatile memory flash for storing voice prompt which combine the use of BBIC to perform ITAD function. 

U2 forms an audio power amplifier to play TAD message and ringer.