Panasonic PT-VW355N / PT-VW355ND / T-VW355NT / PT-VX425N / PT-VX425ND / PT-VX425NT (serv.man2) Service Manual ▷ View online
10
PREFACE
Screen aspect ratio
PT-VW355ND,
PT-VW355NT
PT-VW355NT
16 : 10
PT-VX425ND,
PT-VX425NT
PT-VX425NT
4 : 3
Projection scheme
[FRONT/DESK], [FRONT/CEILING], [REAR/DESK], [REAR/CEILING] (Menu setting system)
Speaker
1 (4.0 cm round-type)
Maximum usable volume
output
output
10 W
Termi-
nals
nals
<COMPUTER 1
IN>
IN>
1 (High-density D-sub 15 pin female)
[RGB signal]
0.7 V [p-p] 75 Ω (When G-SYNC: 1.0 V [p-p] 75 Ω)
HD/SYNC TTL high impedance, automatic positive/negative polarity com
-
patible
VD TTL high impedance, automatic positive/negative polarity compatible
(SYNC/HD and VD do not support 3 value SYNC.)
[YP
B
P
R
signal] Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<COMPUTER 2
IN/1 OUT>
IN/1 OUT>
1 (High-density D-sub 15 pin female)
[RGB signal]
0.7 V [p-p] 75 Ω (When G-SYNC: 1.0 V [p-p] 75 Ω)
HD/SYNC TTL high impedance, automatic positive/negative polarity com
-
patible
VD TTL high impedance, automatic positive/negative polarity compatible
(SYNC/HD and VD do not support 3 value SYNC.)
<VIDEO IN>
1 (Pin jack 1.0 V [p-p] 75 Ω)
<S-VIDEO IN>
1 (Mini DIN 4 pin, Y 1.0 V [p-p], C 0.286 V [p-p] 75 Ω, S1 signal compatible)
<HDMI IN>
1 (HDMI 19 pin, HDCP and Deep color compatible)
Audio signals: Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)
<AUDIO IN>
2 (M3 stereo mini jack, 0.5 V [rms], input impedance 22 kΩ and more)
(<AUDIO IN 2 (MIC IN)> terminal support MIC input)
1 (Pin jack x 2 (L-R), 0.5 V [rms], input impedance 22 kΩ and more)
<VARIABLE AU-
DIO OUT>
DIO OUT>
1 (M3 stereo mini jack, stereo monitor output compatible,
0 V [rms] to 2.0 V [rms] variable, output impedance 2.2 kΩ and less)
<USB A/VIEWER>
USB connector (type A x 1)
<USB B/DISPLAY>
USB connector (type B x 1)
<SERIAL IN>
1 (D-sub 9 pin, RS-232C compliant, for computer control use)
<LAN>
1 (for RJ-45 network connection, PJLink compatible, 10Base-T/100Base-TX)
Power cable length
PT-VW355ND,
PT-VX425ND
PT-VX425ND
3.0 m (118-3/32”)
PT-VW355NT,
PT-VX425NT
PT-VX425NT
2.0 m (78-3/4”)
Cabinet
Molded plastic
Dimensions
Width: 352 mm (13-27/32")
Height: 98 mm (3-27/32") (when the adjustable feet shortened)
Depth: 279.4 mm (11")
Weight
Approx. 3.4 kg (7.5 lbs.) *
6
Noise level *
3
When set to [NORMAL] in [LAMP POWER] : 37 dB
When set to [ECO] in [LAMP POWER] : 29 dB
When set to [ECO] in [LAMP POWER] : 29 dB
Operating environment
Operating environment temperature *
7
: 0 °C (32 °F) to 40 °C (104 °F)
(Elevation: below 1 400 m (4 593′); [HIGH ALTITUDE MODE]: [OFF])
0 °C (32 °F) to 30 °C (86 °F)
(Elevation: 1 400 m (4 593′) ~ 2 000 m (6 562′); [HIGH ALTITUDE MODE]: [HIGH1])
0 °C (32 °F) to 30 °C (86 °F)
(Elevation: 2 000 m (6 562′) ~ 2 700 m (8 858′); [HIGH ALTITUDE MODE]: [HIGH2])
Operating environment humidity: 20 % to 80 % (no condensation)
Remote
control
control
Power supply
DC 3 V (battery (AAA/R03 or AAA/LR03 Type ) x 2)
Operating range
Approx. 7 m (22'11-5/8") (when operated directly in front of receptor)
Weight
102 g (3.60 ozs.) (including batteries)
Dimensions
Width : 48 mm (1-7/8"), Length : 145 mm (5-23/32"), Height : 27 mm (1-1/16")
140 - ENGLISH
Chapter 7 Appendix - Specifications
11
PREFACE
Wireless
LAN
LAN
Specification
standards
standards
MIRRORING
mode
mode
IEEE802.11b/g/n : 2.412 GHz - 2.462 GHz
M-DIRECT
mode
mode
IEEE802.11b/g/n : 2.412 GHz - 2.472 GHz
USER mode
IEEE802.11b/g/n : 2.412 GHz - 2.472 GHz
5.180 GHz - 5.320 GHz
Modulation
DBPSK, DQPSK, CCK, BPSK, QPSK, 16QAM, 64QAM, MIMO
Transmission
speed
speed
IEEE802.11b : Up to 11 Mbps
IEEE802.11g/a : Up to 54 Mbps
IEEE802.11n : Up to 300 Mbps
IEEE802.11g/a : Up to 54 Mbps
IEEE802.11n : Up to 300 Mbps
Wireless channel
MIRRORING
mode
mode
IEEE802.11b/g/n: 1~11 channel
M-DIRECT
mode
mode
IEEE802.11b/g/n: 1~13 channel
USER mode
IEEE802.11b/g/n: 1~13 channel (Passive scanning)
IEEE802.11a/n: 36 / 40 / 44 / 48 / 52 / 56 / 60 / 64 channel (Passive
scanning)
scanning)
Communication
distance
distance
Approx. 30 m (98’5”) (depends on the usage environment)
Security
Infrastructure mode
WPA-PSK (TKIP/AES), WPA2-PSK (TKIP/AES), WEP (128 bit/64 bit),
WPA-EAP/WPA2-EAP (PEAP [MS-CHAPv2/GTC], EAP-FAST [MS-CHAPv2/GTC],
WPA-PSK (TKIP/AES), WPA2-PSK (TKIP/AES), WEP (128 bit/64 bit),
WPA-EAP/WPA2-EAP (PEAP [MS-CHAPv2/GTC], EAP-FAST [MS-CHAPv2/GTC],
EAP-TTLS [MD5/MS-CHAPv2])
*1
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], the network
function (both wireless LAN and wired LAN) cannot be used in standby mode.
*2
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NETWORK], only the
Wake on LAN function can be used in standby mode via wired LAN. When the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [STANDBY MODE] is set to [NETWORK], the power consumption is normally within 6 W in standby
status. If the input source was switched to [MEMORY VIEWER] or [Panasonic APPLICATION] before the projector turns
into standby, the power consumption in standby status may be more than 6 W.
status. If the input source was switched to [MEMORY VIEWER] or [Panasonic APPLICATION] before the projector turns
into standby, the power consumption in standby status may be more than 6 W.
*3 Measurement, measuring conditions and method of notation all comply with ISO21118 international standards.
*4 For details of video signals that can be projected using this projector, refer to “List of compatible signals”. (x page 135)
*5 Pixel-Repetition signal (dot clock frequency 27.0 MHz) only
*6 This is an average value. It may differ depending on individual product.
*7
*6 This is an average value. It may differ depending on individual product.
*7
[LAMP POWER] will be switched to [ECO] automatically when the operating environment temperature is 35 °C to 40 °C.
Note
f The part numbers of accessories and separately sold components are subject to change without notice.
ENGLISH
- 141
Chapter 7 Appendix - Specifications
12
PREFACE
INF-1
CONTENTS
Service Information
Model No. PT-VW355N
PT-VX425N
SECTION 1 SERVICE INFORMATION
(2015-05)
SECTION 1 SERVICE INFORMATION
1. The name of each part . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INF-2
1.1 Projector body
1.2 Control panel / Indicators
1.3 Connecting terminals
1.4 Remote controls
2. Menu Navigation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INF-6
3. Service Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INF-10
3. 1. Setting to Service Mode
3. 2. Cancelling the Service Mode
3. 3. Functions of Service Mode
4. Notes on service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INF-13
4. 1. Before service operation
4. 2. Service
4. 3. Replacement of consumable parts
5. Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INF-18
5. 1. Shutdown system
5. 2. Troubleshooting
Click on the first or last page to see other PT-VW355N / PT-VW355ND / T-VW355NT / PT-VX425N / PT-VX425ND / PT-VX425NT (serv.man2) service manuals if exist.