Panasonic PT-EX16KU / PT-EX16KE (serv.man4) Service Manual ▷ View online
-33-
Mechanical Disassembly
2-1 Lamp cover and PBS cover removal
1 Loosen 1 screw-A and open the Lamp cover.
2 Loosen 1 screw-B and remove the PBS cover.
2 Loosen 1 screw-B and remove the PBS cover.
Lamp cover
PBS cover
A
B
Note on removing the Lamp cover
To avoid the scratch on the cabinet top, put a protec-
tive sheet between the edge of the lamp cover and the
cabinet top.
Open the lamp cover fully until the guide of the groove
ends come on the shafts of the cabinet top and then
gently press top of the lamp cover in the arrow direc-
tion.
To avoid the scratch on the cabinet top, put a protec-
tive sheet between the edge of the lamp cover and the
cabinet top.
Open the lamp cover fully until the guide of the groove
ends come on the shafts of the cabinet top and then
gently press top of the lamp cover in the arrow direc-
tion.
Note on mounting the Lamp cover
Set the guide groove ends of the lamp cover onto the
shafts of the cabinet top. Gently press the handles on
the lamp cover until it clicks.
Set the guide groove ends of the lamp cover onto the
shafts of the cabinet top. Gently press the handles on
the lamp cover until it clicks.
Protective sheet
-34-
Mechanical Disassembly
3 Filter unit removal
1 Loosen 2 screws-A on the filter unit and pull it to remove.
Filter unit
A
2-2 LED board removal
1 Remove 2 screws-A (T3x12) and remove the LED board, RC front window.
LED board
RC front window
A
A A
-35-
Mechanical Disassembly
3-1 Filter unit disassembly-1
1 Loosen 3 screws-A (M3x8) and remove the filter holders upward. Remove the elec-
trostatic
pleat filter upward off.
2 Remove the spacer and remove 3 screws-B (T4x10) and remove the filter front cov-
er.
Electrostatic pleat filter
Filter front cover
A
A
A
B
B
B
Filter holders
Cushion spacer
(Upper side)
(Upper side)
Spacer
-36-
Mechanical Disassembly
4 Main, RC rear board and Shutter removal
1 Remove 8 screws-A (M3x6) to remove the main board.
2 Remove 2 screws-B (M4x6) to remove the shutter assy.
3 Remove 1 screw-C (T4x10) to remove the RC rear board
2 Remove 2 screws-B (M4x6) to remove the shutter assy.
3 Remove 1 screw-C (T4x10) to remove the RC rear board
A
C
B
Main board
RC rear board
Shutter assy
B
A
A
A
A
A
C
A
Note on mounting the Main board
After mounting the main board, confirm that the connectors
on the boards are connected firmly on the following points.
on the boards are connected firmly on the following points.
Main board
Mother board
Bridge board
Confirm connectors
on the boards are
connected firmly
on the boards are
connected firmly
Main board
Mounting
connector
connector
A
Click on the first or last page to see other PT-EX16KU / PT-EX16KE (serv.man4) service manuals if exist.