Panasonic KV-S5055C (serv.man2) Service Manual ▷ View online
13
4.3.
Installing Double-feed Prevention Roller
1. Remove all packing tape.
2. Push the ADF Door Release (1) to open the ADF door (2).
3. Pull towards you and remove the Double-feed Prevention
Roller Cover by using the indent (1).
Roller Cover by using the indent (1).
4. Install the Double-feed Prevention Roller.
• Align the shaft that is shaped as indicated by (1) with the
notch in the roller mount (2), and then insert the shaft in the
notch. Push the shaft on the opposite side (3) until it clicks into
place.
notch. Push the shaft on the opposite side (3) until it clicks into
place.
Note
After you install the Double-feed Prevention Roller, make sure
that the shaft is inserted into the tab, and that the shaft will not
rotate or move. If the roller is not installed correctly, it may
cause double feeding or a paper jam.
that the shaft is inserted into the tab, and that the shaft will not
rotate or move. If the roller is not installed correctly, it may
cause double feeding or a paper jam.
14
5. Insert the protrusion (1) of the Double-feed Prevention Roller
Cover into the holes on the main unit, and then push in the
part of the roller cover indicated by (2) in the direction indicated
by the arrows until it clicks into place.
Cover into the holes on the main unit, and then push in the
part of the roller cover indicated by (2) in the direction indicated
by the arrows until it clicks into place.
Note
Make sure that the Double-feed Prevention Roller Cover does
not stick up.
If the cover is not closed properly, paper jams or damage to
the paper may occur.
not stick up.
If the cover is not closed properly, paper jams or damage to
the paper may occur.
6. Close the ADF Door.
• Push both sides of the ADF Door down slowly until it clicks into
place.
15
4.4.
When Scanning Documents of Different Sizes Together
Note
See the following conditions for scanning documents of different sizes together.
• Document thickness
The ratio of the thickness between the thickest paper and thinnest paper must be less than 1.5.
• Document size
The ratio of the largest paper size to the smallest paper size must be less than 1.5. (The minimum size is A6)
For example, if A4 is the smallest paper set on the Hopper, the maximum size for other documents to be scanned together
is A3.
For example, if A4 is the smallest paper set on the Hopper, the maximum size for other documents to be scanned together
is A3.
1. Set the Manual Feed Selector to "AUTO".
2. Slide the Document Guides Selector in the direction of the
arrow to unlock the Document Guides so that the guides
can be slid independently from each other.
arrow to unlock the Document Guides so that the guides
can be slid independently from each other.
16
3. Spread the Document Guides as far apart as they will go.
4. Align the documents along one side of the guides.
5. Slide the Document Guides to align the document position so
that the center of the smallest sheet can be fed into the center
of the paper slot.
that the center of the smallest sheet can be fed into the center
of the paper slot.
Note: Adjusting the left and right Document Guides to
their original position
1. Slide the Document Guides Selector to unlock the
Document Guides.
2. Spread the Document Guides as far apart as they will
go.
3. Slide the Document Guides Selector to lock the
Document Guides.
Click on the first or last page to see other KV-S5055C (serv.man2) service manuals if exist.